刀杆是加工中心和精密机床的重要附件之一,在热处理过程中,表面粘附油腻、残盐或其它污垢。如清洗不净,不但不易检查在热处理过程中产生的缺陷,而且还易腐蚀,影响刀杆的热处理质量和电镀质量。目前,我国对热处理零件的清洗,通常采用的是清洗槽,配制一定浓度的清洗液,加热浸煮的办法。清洗液在工作过程中不断浑发和被工件带走,使溶液变浓减少,而又不允许经常更换溶液,从而影响了清洗工作的顺利进行。尤其是盲孔、通孔和凹槽,难以彻底清洗而工作表面只要有少量残盐存在,就能引起 Arbor is a machining center and precision machine tools, one of the important annex, in the heat treatment process, the surface adhesion of greasy, residual salt or other dirt. Such as cleaning is not clean, not only not easy to check the defects generated in the heat treatment process, but also easy to corrode, affecting the quality of heat treatment and plating quality Arbor. At present, China’s heat treatment of parts cleaning, usually used is cleaning tank, the preparation of a certain concentration of cleaning fluid, heating dipping approach. Cleaning fluid in the work process constantly muddy and be taken away by the workpiece, so that the solution to reduce the concentration, but does not allow frequent replacement of the solution, thus affecting the smooth cleaning work. In particular, blind holes, through-holes and grooves make it difficult to thoroughly clean the surface of the work surface as long as there is a small amount of residual salt present