我国现在的初轧机、大型轧钢机及轧板机的一些附属设备,如:单独辊道的非传动端轴承座、推床轴瓦、垛板机传动轴轴承座和翻板机大轴轴承座等,都是通过自动干油站的干油泵打油,经过管路、给油器,最后由给油器分送到各润滑点。每个生产班打油2～4次。每个润滑点所接受的干油(一般是钙钠基润滑脂),在运转中利用有限,大部分流失,轴承座下都有漏油。不仅浪费,又影响工业卫生。轧板厂,在党委的领导下,大搞技术革新和技术革命,几年来,在轧板厂进行了几项小改进,设备面貌有所改变,工业卫生良好。提高了生产效率。 Our country now the first rolling mill, rolling mill and rolling mill some of the ancillary equipment, such as: roller table of the non-transmission side of the bearing, push bed bearing paddle drive shaft bearing and flap machine shaft bearing, etc. , Are through the dry oil pump station dry oil, through the pipeline, to the oil, and finally sent by the oil to the lubrication points. Fighting oil for each production class 2 ~ 4 times. Dry oil received at each lubrication point (usually calcium-based grease), limited use in operation, most of the loss of oil leakage under the bearing. Not only waste, but also affect industrial hygiene. Under the leadership of the party committee, the mill has vigorously engaged in technological innovation and technological revolution. In the past few years, several small improvements were made in the rolling mill. The face of the equipment has been changed and the industry is in good health. Improve production efficiency.