论文部分内容阅读
在建筑施工中,架子工搭设斜道应严格遵循以下安全技术规定:(1)斜道的坡度以1∶3为准。宽度不小于1.5 m(超过2 m时应搭双支柱)一律绑之字或元宝斜道。(2)绑斜道先立里皮杆子,横杆绑在立杆的外边,预留出斜道的过门。(3)斜道的外架子与原有的立杆对准,斜道横杆与原横杆取成水平线,斜道两头于中间必须绑剪刀撑。(4)走手推车及浇灌混凝土的单坡斜道,其坡度应以1∶7为宜,宽度应大于2 m(两台手推车能错开)。立杆每隔5根应设剪刀撑,斜道上应绑扶手和拴安全网。(5)对于搬运重量大或有特殊要求的斜道,过道应经过计算后绑扎。(6)斜道上铺设的板子应满铺对头板,接头部位应用钉子将其钉牢。
In building construction, racking workers should be strictly follow the following safety rules and regulations: (1) ramp slope to 1: 3 prevail. Width of not less than 1.5 m (more than 2 m should be taken when the two pillars) are bound word or ingot ramp. (2) tied the first mile Li Pei pole, crossbar tied to the pole of the outside, set aside a ramp of the door. (3) The ramps of the outer shelf alignment with the original pole, the ramp crossbar and the horizontal bar to take the horizontal line, both ends of the ramp in the middle of the scissors must be tied scissors. (4) Strollers and single-slope chutes for watering concrete shall have a grade of 1: 7 and a width of more than 2 m (two trolleys can be staggered). Pole every 5 should be set scissors, ramps should be tied handrails and safety net tied. (5) For the handling of heavy or have special requirements of the ramp, the corridor should be calculated after the banding. (6) slats laid on the board should be full of counter-board, nail the nail joints to nail it.