Diffusion Characteristic of Sulfate Anion in Surface Region of Cement Mortar at Early Stage

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:silawangyue
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The SO42-concentration distributions in surface region of cement mortar immersed in sulfate solution at early stage were measured by layered sampling method combined with chemical analysis,and the diffusion coefficients of SO42-anions in surface region of mortar into internal area were calculated by means of instantaneous plane diffusion theory.The experimental results showed that the SO42-concentration gradually reduced when the diffusion depth increased in the surface region of mortar.Diffusion coefficient (D) was relevant with the concentration and kind of environmental sulfate solution,which reduced with immersion time at the beginning,and then rose slowly after a period of time.The calculation of initial diffusion coefficient (D0) and starting time of deterioration (t∞) caused by sulfate attack was further attempted based on the data of diffusion coefficient,and it was found that D0 and t∞ were all relevant with concentrations of sulfate and different kind of sulfate as well.
其他文献
Palygorskite/paraffin phase-change composites were prepared by the combination of purified palygorskite clay and sliced paraffin. Then, this composite was used in the Trombe wall to improve its energy storage ability. Further, its energy storage ability w
Four Nb-Ti microalloyed steels were refined and rolled to study the composition optimization of Nb-Ti microalloyed steels.The effects of Nb and Ti on the microstructures,precipitates and properties of Nb-Ti microalloyed steel were investigated.The results
The functional groups on graphene sheets surface affect their dispersion and interfacial adhesion in polymer matrix. We compared the mechanical property of polymethymethacrylate (PMMA) microcellular foams reinforced with graphene oxide (GO) and reduced gr
The damage mechanism and energy dissipation of the Polyethylene (PE) laminates in impacting was investigated. It was found that the dissipated energy of the impacting sphere bullet by the 1-mm-thick PE plate firstly increased with the impacting velocity i
In order to examine the effect of extrusion ratio on the microstructure and mechanical behavior in Al-Cu-Mg-Ag alloy, the Al-6.3Cu-0.48Mg-0.4Ag alloy was subjected to extruding with different extrusion ratios of 17, 30 and 67. The results indicate that th
Banana pseudo-stem was liquefied in the mixture of polyhydric alcohols of polyethylene glycol (PEG400) and glycerol. Hydroxyl value of liquefied products ranged from 294.8 to 370.2 mg KOH/g and Mn was about 430. Liquefied products (LBPP) could be used as
The dynamic load characteristics of a proton exchange membrane fuel cell (PEMFC) with a dead-ended anode were studied. In a 70 h experiment, the effects of anode pressure, operating temperature, and relative humidity of the cathode on the performances of
To enhance the understanding about the utilization of steel slags as a cementitious material, we comparatively studied the chemical, mineralogical and morphological properties of two types of steel slag; basic-oxygen-furnace carbon slag (BOF C) and electr
In order to distinguish the filling effect and volcanic activity and explore the ways motivating the activity of rich-silicon iron ore tailing(IOT),inert quartz was brought in as the correction standard,the influences of fineness,calcination,thermal curin