The physical characteristics of coal reservoirs are important for evaluating the potential for gas desorption,diffusion,and seepage during coalbed methane(CBM)production,and influence the performance of CBM wells.Based on data from mercury injection experiments,low-temperature liquid nitrogen adsorption,isothermal adsorption,initial velocity tests of methane diffusion,and gas natural desorption data from a CBM field,herein the physical characteristics of reservoirs of high-rank coals with different coal-body structures are described,including porosity,adsorption/desorption,diffusion,and seepage.Geometric models are constructed for these reservoirs.The modes of diffusion are discussed and a comprehensive diffusion-seepage model is constructed.The following conclusions were obtained.First,the pore distribution of tectonically deformed coal is different from that of normal coal.Compared to normal coal,all types of pore,including micropores(<10 nm),transitional pores(10-100run),mesopores(100-1000 nm),and macropores(>1000 nm),are more abundant in tectonically deformed coal,especially mesopores and macropores.The increase in pore abundance is greater with increasing tectonic deformation of coal;in addition,the pore connectivity is altered.These are the key factors causing differences in other reservoir physical characteristics,such as adsorption/desorption and diffusion in coals with different coal-body structures.Second,normal and cataclastic coals mainly contain micropores.The lack of macropores and its bad connectivity limit gas desorption and diffusion during the early stage of CBM production.However,the good connectivity of micropores is favorable for gas desorption and diffusion in later gas production stage.Thus,because of the slow decline in the rate of gas desorption,long-term gas production can easily be obtained from these reservoirs.Third,under natural conditions the adsorption/desorption properties of granulated and mylonitized coal are good,and the diffusion ability is also enhanced.However,for in situ reservoir conditions,the high dependence of reservoir permeability on stress results in a weak seepage of gas;thus,desorption and diffusion is limited.Fourth,during gas production,the pore range in which transitional diffusion takes place always increases,but that for Fick diffusion decreases.This is a reason for the reduction in diffusion capacity,in which micropores and transitional pores are the primary factors limiting gas diffusion.Finally,the proposed comprehensive model of CBM production under in situ reservoir conditions elucidates the key factors limiting gas production,which is helpful for selection of reservoir stimulation methods. The physical characteristics of coal reservoirs are important for evaluating the potential for gas desorption, diffusion, and seepage during coalbed methane (CBM) production, and influence the performance of CBM wells. Based on data from mercury injection experiments, low-temperature liquid nitrogen adsorption , isothermal adsorption, initial velocity tests of methane diffusion, and gas natural desorption data from a CBM field, herein the physical characteristics of reservoirs of high-rank coals with different coal-body structures are described, including porosity, adsorption / desorption, diffusion, and seepage. Geometric models are constructed for these reservoirs. The modes of diffusion are discussed and a comprehensive diffusion-seepage model is constructed. the following conclusions were obtained. First, the pore distribution of tectonically deformed coal is different from that of normal coal. Compared to normal coal, all types of pore, including micropores (<10 nm), transitional pores (10-100 run), mesopores 00-1000 nm), and macropores (> 1000 nm), are more abundant in tectonically deformed coal, especially mesopores and macropores. The increase in pore abundance is with increasing tectonic deformation of coal; in addition, the pore connectivity is altered. These are the key factors causing differences in other reservoir physical characteristics, such as adsorption / desorption and diffusion in coals with different coal-body structures. Second, normal and cataclastic coals mainly contain micropores. The lack of macropores and its bad connectivity limit gas desorption and diffusion during the early stage of CBM production. However, the good connectivity of micropores is favorable for gas desorption and diffusion in later gas production stages. Thus, of of the slow decline in the rate of gas desorption, long-term gas production can easily be obtained from these reservoirs.Third, under natural conditions the adsorption / desorption properties of granulated and mylonitized coal are good, and the diffusionfor desorption and diffusion is limited. Fourth, during gas production, the pore range in which transitional diffusion takes place always increases, but that for Fick diffusion decreases. This is a reason for the reduction in diffusion capacity, in which micropores and transitional pores are the primary factors limiting gas diffusion. Finally, the proposed comprehensive model of CBM production under in situ reservoir conditions elucidates the key factors limiting gas production, which is helpful for selection of reservoir stimulation methods.