用电解加工方法加工深小方孔和狭缝夹角小于60°等型腔尚存在一些困难。采用连续振动进给和间隙供电法,就可以有效地解决这种困难。振动进给在电解加工深小方孔和狭缝夹角小于60°的复杂零件时是无法用电解液反流法的。而采用电解液正流法时,由于流场不均匀,流动混乱,因此容易在阴极狭小夹角处产生烧伤现象。如果在加工中给工具 Electrolytic processing of deep and small square hole and the slit angle is less than 60 ° and other cavity there are still some difficulties. The use of continuous vibration feed and gap power supply method, you can effectively solve this difficulty. Vibrating feed is not able to be back-flowed with electrolyte during the electrolysis of complex parts with small square holes and slit angles of less than 60 °. When using the positive flow method of the electrolyte, the flow phenomenon is not uniform and the flow is chaotic. Therefore, it is easy to cause burn phenomenon at a narrow angle of the cathode. If given to the processing tool