汽化器出毛病,一般是汽化器盖上的螺纹磨损或产生裂纹,汽化器壳体与喉管配合处磨损等。我厂对螺纹的磨损或裂纹采用焊修的方法来修理,现介绍如下。 1.焊条的准备用报废的汽化器熔化浇出,熔化用的勺子如图所示。勺子上砸一小窝,并在此处钻φ3孔1～2个。将勺子放在炉上加温,勺前部翘起,使熔化了的金属不致于从小孔中流出。熔化完毕迅速倾倒 Carburetor out of the disease, the carburetor is usually worn on the thread wear or cracks, carburetor shell and throat with wear and tear and so on. I plant on the thread wear or crack repair method using welding repair, are described below. 1. Preparation of welding rod with the scrap melting carburetor pouring out, melting the spoon as shown. Hit a spoon on the spoon, and drill holes here φ1 1 ~ 2. Place the spoon on the stove to warm the front of the spoon. The melted metal will not flow out of the holes. Melted quickly dumped