• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 会议论文
  5. Studies on the quantitative composition design of alloys with the use of the empirical electronic th

Studies on the quantitative composition design of alloys with the use of the empirical electronic th

来源 :1st International Conference on Computational Design and Sim | 被引量 : 0次 | 上传用户：luowanda
【摘 要】
：
　　The empirical electronic theory (EET) of solids and molecules was established in 1978 by Ruihuang Yu.This theory can exhibit the systematic energy and elect
【作 者】
：
ChengLin[1]GuiliYin[1]YongqingZhao[2] 
【机 构】
：
College of Materials Science and Engineering, Liaoning University of Technology, Jinzhou,Liaoning, C
【出 处】
：
1st International Conference on Computational Design and Sim
【发表日期】
：
2015年期
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
　　The empirical electronic theory (EET) of solids and molecules was established in 1978 by Ruihuang Yu.This theory can exhibit the systematic energy and electron distribution in real space, and its calculation method is simple and practical.Among the numerous applications of EET, the studies on the quantitative composition design based on the EET are most attractive.In this paper, we exhibit the new methods about the composition design of alloys.
其他文献
Analyzing standing waves on periodic waveguides by pseudospectral modal method
　　For some periodic waveguides, there are standing waves, which are special guided modes, non-propagating and localized around the waveguide core.These non-pr
会议
Digital material analysis methods based on computer vision
　　Machine Vision is a method replaces eye measure and estimate, Image acquisitions device getting target image then switches it into digital signal.Send it to
会议
Discussion on the methods to calculate austenite static recrystallized faction
　　Double deformation technique is often used to study static recrystallization behavior of materials and static recrystallization fraction can be calculated b
会议
The study of stress-strain reconstruction method based on EMD
　　At present, an effective means of structural health monitoring is through the installation of monitoring instruments to monitor the state of the system, one
会议
Angle and the accuracy of springback steel bar bending hoop stirrup
　　The hooked steel will spring back under the effection of residual stress, in order to improve the precision of the hoop, springback angle should be taken in
会议
FEM simulation and evaluation for large marine crankshaft manufacturing process
　　Crankshaft is one of the most important components in the large vessels, which act as the heart of diesel engine.Manufacturing the crankshaft runs a long co
会议
Modeling of ferrite-austenite phase transformation in low-carbon steels
　　A two-dimensional cellular automaton (CA) model is adopted to simulate the ferrite (α)-austenite (γ) transformation in low-carbon steels.The nucleation of
会议
Interpolation of experimental results for heat capacities of thallium and cobalt aluminates
　　According to the theoretical foundations [1-3], let us regard the stable phases of the system Al2O3-Tl2O3.They are TlAl3O6, TlAl7O12, TlAl11O18 and produced
会议
The heredity of icosahedrons: a kinetic factor affecting GFA of rapidly solidified CuxZr100-x alloys
会议
Probability distribution and fuzzy system based on triple I algorithm
　　In the paper, probability distribution and fuzzy system based on the triple I algorithm and modified Reichenbach operator are discussed.Firstly, the joint p
会议