Nanoscale Hollow-bubbly Polypyrrole Obtained via Interfacial Polymerization with Phase Transfer Cata

来源 :2014中国功能材料科技与产业高层论坛 | 被引量 : 0次 | 上传用户:jinxiangjinshu
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Crown ether 18C6 was used as a phase transfer catalyst (PTC) for the interracial polymerization of polypyrrole (PPy).Usually, in interfacial reacting system, oxidant FeCl3 was dissolved in deionized water to form aqueous phase, while pyrrole was dissolved in chloroform to form organic phase.
其他文献
Co68.25Fe4.5Si12.25B15 amorphous microwires with a diameter of 34 μm wereprepared via the melt extraction method.The dependency of AC driving current Iac on giantmagneto-impedance (GMI) effect and mag
以ZrB2和SiC超细粉体为主要原料,经热压烧结和线切割加工制成ZrB2-SiC复合陶瓷发热元件,利用XRD及SEM分析了该复合陶瓷的微观结构。通过不同高温实验考察了发热元件分别在氩气、空气和氮气气氛下的表面侵蚀程度与温度的关系并确定其对应的临界温度。
In order to reduce the releasing rate of nanosilver in solutions, the carbon nanotube was selected to combine with nanosilver.The higher dispersion of Ag nanoparticles (AgNPs)was in-situ prepared on t
Mandarin oil were extracted twice to ensure the purity of limonene, respectively.The spectrum testandSolvent solubility of chemical analysis indicate that it is a certain fluorescence effect and the u
Ni50-xMn37In13Cox (x=0,5) alloy powders were obtained by ball-milling from the corresponding ribbonprecursors.The as-milled NixMn37In13 and Ni45Mn37In13Co5 powders show disordered fct and fcc structur
采用化学氧化界面聚合法,以FeCl3为氧化剂,以吡咯为单体,在相转移催化剂辅助下合成聚吡咯薄膜。利用扫描电子显微镜、热失重分析及电化学测试(循环伏安测试、交流阻抗测试)对其结构与性能的变化进行了研究。
TiO2 photocatalysts doped with different element of C and Y were synthesized by sol-gel process using glucose, yttrium nitrate and tetrabutyl titanate as precursors.Samples characterized by XRD, XPS,
为实现镁合金AZ31B与工业纯铜的可靠连接,以Al为中间层对两者进行过渡液相扩散焊的瞬间液相扩散焊.研究结果表明,在460℃、60 min、2.5 MPa条件下,AZ31B/Al/Cu接头形成了宽度约为160μm的扩散区.
Quantum dots sensitized solar cells (QD-SCs) have high theoretical conversion efficiency, and they have potential application in energy field.But the conversion efficiency of QDSCs have not made a big
Tungsten was considered a promising plasma facing material in fusion device due to its high sputtering threshold, the high melting point,and so on.