Numerical Simulation of Annual Change Patterns of Contemporary Tectonic Stress-Strain Field of the C

来源 :中国地震研究(英文版) | 被引量 : 0次 | 上传用户:btly540205390
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Based on the active crustal block structures, the Holocene active faults and the wave velocity structures with a resolution of 1°× 1°, a two-dimensional finite element model for the tectonic stress-strain field of the Chinese mainland is constructed in the paper. Using GPS measurements, the velocity boundary conditions for the model are deduced, then, the annual change patterns of the present-day stress-strain field of the Chinese mainland are simulated.The results show that (1) the general pattern of the recent tectonic deformation in the Chinese mainland is governed by the interactions of its surrounding plates, of which, the Indian Plate plays a major role. There is a NNE-directed velocity distribution in the west of the Chinese mainland. The maximum slip rate appears at the collision boundary. The north-directed components decrease, while the east-directed components increase gradually from south to north and from west to east. In the east part, there is a general east-directed movement, with a certain amount of south-directed components. (2) The present-day tectonic stress field in the Chinese mainland has undergone the process of enhancement in recent years, and this process presents a general pattern of radiating eastwards from the Qinghai-Xizang (Tibet) Plateau as the center. The general pattern is similar to the ambient tectonic stress field, indicating the inheritance of contemporary tectonic deformation on the Chinese mainland. (3) The maximum principal strain presents an obvious pattern of being high in the west and low in the east. The tectonic movement in the west is stronger than that in the east. Large active faults are all located in the high-value zones of maximum principal strain. However, the magnitude of strain is smaller in the interior of the active crustal blocks, which are enclosed by these faults. (4) The stress-strain field of the Sichuan-Yunnan region is unique. It may not be governed by collision of plates alone but a combination of the movement of peripheral active blocks,material flow in the lower crust or upper mantle and special tectonic geometry (such as the eastern Himalayan syntax) as well.
其他文献
研究了微陀螺的电容变化率为10-7~10-8时的微弱输出信号的检测技术,这是微机械器件研制中具有普遍性的技术难点。在研究检测微小电容变化量的积分电路的基础上,进一步采用了可
简要阐述了发展微机在线监测系统是解决鼓风机运行监护的发展趋势.在论述了鼓风机的常见故障之后,讨论了用于鼓风机监测诊断的传感器选择及微机在线监测系统功能的确定.并详
1 视歧患者童某,男,49岁,因两目胞红肿,红膜布满气轮,泪多眵多,恶寒发热,脉浮弦,舌苔白厚而就诊.
首先介绍了微功率冲激雷达(MIR)的性能特点,讨论了超宽带雷达的动目标检测特性,进而分析了MIR 的动目标检测原理,提出了采用BOXCAR积分器实现MIR 动目标检测的方法。 Firstly, the performance c
研究了用 1颗或 2颗GPS卫星进行低轨卫星初轨计算的问题 :给出了基于线性变换的初值计算方法 ;并以此为迭代起点 ,分别用割线法、Newton下降法以及同伦延拓法等综合算法解算非线性方程组 .计算机仿真结果证明 :整个算法能在较短时间内给出低轨卫星的初轨 ,并保证一定的精度
报道了钛合金TC11 对轴承钢GCr15 在室温到450 ℃大气环境下,激光淬火前后球盘对比研究。结果表明,经激光处理后,钛合金在150 ℃和300 ℃抗磨能力明显提高,但在室温和450 ℃改善不明显。 Reported tit
在原先齿轮强度可靠性设计中,强度和应力均按正态分布近似处理,计算精度较低。将齿面接触疲劳强度按威布尔分布、应力按正态分布处理,将齿根弯曲疲劳强度和应力均按对数正态分布
故障定位是电力系统事故处理的前提.传统的专家系统方法需要建立复杂的知识库,且实时性得不到保证.文中论述了利用因果网技术进行故障定位的方法,因果网描述了故障元件、继电
In this work, the effect of microsilica addition on properties of mullite-corundum ceramic specimens fired at temperatures from 1550℃ to 1700℃ has been invest
The Amery Ice Shelf is the largest ice shelf in East Antarctica. A new DEM was generated for this ice shelf, using kriging to interpolate the data from ICESat a