【摘 要】
：
To solve the problems with coronary stent implantation, coronary artery stent surface was directly modified by three-beam laser interference lithography through imitating the water-repellent surface of lotus leaf, and uniform micro- nano structures with t
【机 构】
：
SchoolofOptoelectronicEngineering,ChangchunUniversityofScienceandTechnology,Changchun130022,ChinaThe
【出 处】
：
OptoelectronicsLetters
论文部分内容阅读
To solve the problems with coronary stent implantation, coronary artery stent surface was directly modified by three-beam laser interference lithography through imitating the water-repellent surface of lotus leaf, and uniform micro- nano structures with the controllable period were fabricated. The morphological properties and contact angle (CA) of the microstructure were measured by scanning electron microscope (SEM) and CA system. The water repellency of stent was also evaluated by the contact and then separation between the water drop and the stent. The results show that the close-packed concave structure with the period of about 12 μm can be fabricated on the stent surface with special parameters (incident angle of 3°, laser energy density of 2.2 J·cm-2and exposure time of 80 s) by using the three-beam laser at 1 064 nm, and the structure has good water repellency with CA of 120°.
其他文献
日本富士通研究所报导了一种首次用于5 Gb/s远距传输实验而不产生背景误差和只有很少色散的单片器件。由于非正常再生长所产生的不完善钮接妨碍了其它单片器件的高功率运转。该所研究人员通过在导引层上引进一种含有InP薄蚀刻顶层新结构而解决了上述问题。结果，这种单片高功率电吸收调制器/分布 反馈激光源的总输出功率达5 mW，这是迄今报导的最高功率。
Deep learning in the context of nano-photonics is mostly discussed in terms of its potential for inverse design of photonic devices or nano-structures. Many of the recent works on machine-learning inverse design are highly specific, and the drawbacks o
为了实现运动模糊图像的盲复原,提出了一种基于l_1/l_2的高低阶全变差图像盲复原方法。利用具有更强稀疏表达能力的l_1/l_2范式正则化先验项,加入高低阶混合全变差正则化模型。高阶全变差正则化模型可以抑制图像非边缘部分可能出现的阶梯及振铃效应,低阶全变差正则化模型可以保护自然图像的边缘稀疏特性。分别给出了清晰图像和模糊核的求解算法,两者的求解过程采用分裂Bregman迭代算法将目标函数分裂成多个
Based on the experimental researches on the fluorescence spectra of 1% erythrocyte solution with various concentration of alcohol excited by violet light-emitting diode LED light at 407 nm, the mechanism of alcohol on the fluorescence spectra of erythrocy
提出了一种可应用于CMOS图像传感器的联合并行图像预处理算法，其中，色彩插值算法采用双线性插值法和边缘导向插值法相结合的方式来完成色彩还原，而降噪算法采用带阈值的空间自适应滤波降噪算法，在硬件语言描述算法时，将两种算法的处理过程进行了联合处理。实验仿真结果表明，通过对算法进行ISE仿真和Matlab显示处理，得到色彩饱和度较高的彩色图像，峰值信噪比（PSNR）为30~36dB。整个处理过程有效地简化了片上系统（SOC）的图像处理过程，提高了算法的运算速度，节省了芯片面积且降低了系统功耗，为CMOS图像传感
Laser materials for eyesafe wavelength generation and Q-switching crystals for short pulse operation were studied. Er,Yb:phosphate glass as a laser crystal and Co2 :MgAl2O4 as a saturable absorber were found to be an effective pair for a compact, light-we
激光雷达方程求解时将后向散射消光对数比k作为假设值,推导了k与波长指数、探测波长及气溶胶消光系数之间的关系式,提出了一种确定k值的新方法。利用532nm瑞利-拉曼-米氏散射激光雷达及微脉冲激光雷达,结合CE-318太阳光度计观测数据,对k在不同天气条件下的取值进行了初步研究,引入能见度因子,估算气溶胶消光系数,对该方法进行验证。结果表明:空气状况良好时,仅在k值取1.0时气溶胶消光系数更接近能见度
内面镀有碘化银和银(AgI/Ag)的空芯光纤在中红外波段已有较成熟的制备工艺并得到广泛应用。由于AgI膜厚和表面粗糙度的控制存在较大难度，近红外低损耗的AgI/Ag空芯光纤尚未见报道。通过一系列工艺改进，包括以酒精作为碘的溶剂，在低温中对银膜进行碘化，并采用真空泵提高并稳定碘溶液流速，制备了碘化银膜厚为70 nm的AgI/Ag空芯光纤。实现了AgI/Ag空芯光纤在近红外区域的低损耗传输。采用发光波长为1.064 μm的二极管抽运固体激光器系统测得长度为1 m、内径为0.7 mm的AgI/Ag空芯光纤损耗约
本文提出共振双光子吸收光谱的一种新的实验方法.实验装置与双光子荧光法测超短脉冲脉宽的装置是一样的.在测定了信号强度的反差比以后可以推知完全共振双光子吸收截面与两步单光子吸收截面之比值.理论计算表明,本方法的适用范围是相当大的.