论文部分内容阅读
自《轧机人字齿轮断轴粘接修复》及《断轧辊粘接技术应用》文章在《江西冶金》杂志发表后,不少厂矿来人来函询问、探讨粘接技术。本文再介绍粘接技术在我厂应用的部份实例,与兄弟单位进一步交流。 一、断轴类另件的定位粘接 例1:我厂 4根φ250×5轧机上的人字齿轮断轴用此方法连接,投产应用两年多来,一直运转正常,至今仍在使用。 例2:断轧辊粘接也是采用套式定位结构,已成功粘接多根轧辊,使用效果良好。
Since the publication of the article, “Repair and Repair of Broken-off Horn of Hitachi Rolling Mill” and “Application of Abutment Roller Bonding Technique”, many factories and mines came to inquire and discussed bonding technology after the publication of “Jiangxi Metallurgical” magazine. This article will then introduce some examples of adhesive technology applied in our factory, and further exchanges with our brother unit. First, the other parts of the broken shaft bonding Example 1: I plant 4 φ250 × 5 Herringbone gear on the mill off the shaft connected by this method, put into operation more than two years, has been operating normally, is still in use. Example 2: broken roller bonding is also used nested positioning structure has been successfully bonded to a number of rollers, the use of good results.