输送机胶带粘结时,要把胶带做成阶梯状(如图1所示),然后涂胶,再把接1.胶层 2、3、4.帆布层图1图2头搭接在一起。现接头的制作是:先用刀具在胶带上划一道横沟,把上面的胶层撕去,然后再划帆布,撕帆布,依次阶梯状往下推。如果一刀划得太深(如划胶带时把下面的帆布层也划破了), Conveyor tape bonding, the tape should be made ladder (as shown in Figure 1), and then glue, and then 1. Adhesive layer 2,3,4. Canvas layer Figure 1 Figure 2 Lap lap together . Now the joint production is: first with a knife in the tape to draw a horizontal groove, the top of the plastic layer ripped off, and then draw canvas, tear canvas, followed by a ladder-like push down. If the knife is too deep (such as when the tape to draw the canvas below also scratched)