论文部分内容阅读
图1所示为红旗轿车上一个零件(零件厚度为2毫米),该零件采用落料冲孔复合模制造是很困难的,因为凸凹模的强度太薄弱。我们采用了一套带有自动挡料装置的连续模来制
Figure 1 shows a red car on a part (part thickness of 2 mm), the parts blanking punching composite model is very difficult to create, because the punch and die strength is too weak. We used a continuous mode with automatic stop device