论文部分内容阅读
三河市刷镀技术研究所长期研究探讨刷镀技术,使镀层厚度达到了5mm。取得可喜成果。该所刷镀的机械零件不受形状、大小及场地限制,可在野外、车间现场流动作业,重型零部件可不拆卸,就地修复;刷镀过程的加热温度不大于70℃,不会造成零部件变形及金相组织变化,刷镀采用计时器控制,镀层厚度在0.30mm以下时精度可达0.01mm能方便地选用镀层的种类和调整镀层的硬度,最高硬度可达HRC58～62。下面介绍应
Sanhe Brush Plating Technology Research Institute of long-term research brush plating technology, the coating thickness of 5mm. Achieve gratifying results. The plated mechanical parts are not limited by the shape, the size and the site, and can be flowed in the field and on the workshop. The heavy parts can be repaired on-site without any dismantling. The heating temperature of the brush plating process is not more than 70 DEG C and will not cause zero Parts deformation and microstructure changes, brush plating timer control, the coating thickness of 0.30mm below the accuracy of up to 0.01mm can easily choose the type of coating and adjust the hardness of the coating, the maximum hardness of up to HRC58 ~ 62. The following should be