钨丝探针电解预富集-石墨炉原子吸收法测定罐头食品中痕量锡

来源 :分析化学 | 被引量 : 0次 | 上传用户:liuliyuanll
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
采用钨丝探针电解预富集 石墨炉原子吸收法测锡 ,兼有电解预富集和探针原子化的优点。对电解液组成、溶液pH值、电解电压、富集时间等实验条件进行了优化。方法检出限达到 0 .0 8μg L ;相对标准偏差为 5 .6 %。应用于罐头食品中痕量锡的测定 ,结果满意。初步探讨了锡在电沉积后的原子化机理。 The use of tungsten wire probe electrolysis pre-enrichment graphite furnace atomic absorption spectrometry tin, both the advantages of pre-enrichment and probe atomization. The electrolyte composition, pH value, electrolysis voltage, enrichment time and other experimental conditions were optimized. The method detection limit reached 0.08 μg L; the relative standard deviation was 5.6%. Used in canned food trace tin determination, the results are satisfactory. The atomization mechanism of tin after electrodeposition was preliminarily discussed.
其他文献
为改善催化剂中γ-Al2O3分散层与FeCrAl基体的结合力,采用等离子喷涂技术在合金表面制备了NiCrAl/ZrO2混合涂层作为过渡层.利用X射线衍射仪、扫描电镜和电子探针仪,研究了1 0
To cope with the ever-increasing susceptibility to transient fault in modem processors, a scheme called Tri-modular Redundantly and Simultaneously Threaded proc
The poly(butylene succinate-co-terephthalate) (PBST) copolyesters with different monomer composition were synthesized by polycondensation. The isothermal crysta
报道了一台连续792 nm Ti∶Al2O3激光器纵向抽运的(Tm,Ho)∶YLF微片激光器.在室温条件下,当抽运功率为680 mW时,激光器在2.06 μm波长的输出功率达到90 mW.激光器阈值为380 m
This paper describes a data reconstruction technique for a multi-function sensor based on the Mestimator, which uses least squares and weighted least squares m
Clustering routing protocols excel in several aspects of wireless sensor networks (WSNs). This article proposes a clustering and multihop routing protocol (CMRP
期刊
应用多重散射方法计算了二维介质柱构成的非晶光子材料的缺陷态。在非晶光子材料中抽掉不同位置的圆柱会产生频率不同的缺陷模 ,但缺陷模的能量都是非常局域的 ,能量基本上集
The effects of rare earth (RE) on the microstructures and properties of high carbon high speed steel (HCHSS) were investigated. The results show that when suita
An experimental investigation of three-dimensional flow field in a film-cooled turbine model is carried out by using particle image velocimeter (PIV) in a low-s
In consideration that behavior of curvature ductility of interior support directly influences the degree of moment modification of unbonded prestressed concrete