【摘 要】
：
In order to research how lignite is utilized, two coal samples of seams 2 and 4were taken from the Huangxian Basin, China. The samples were separated into vitrinite,sporinite, and resinite. Geo-chemical and pyrolysis methods were used to analyse three mac
【机 构】
：
School of Management, Tianjin University, Tianjin 300072, China; Department of Energy Resource, Hebe
论文部分内容阅读
In order to research how lignite is utilized, two coal samples of seams 2 and 4were taken from the Huangxian Basin, China. The samples were separated into vitrinite,sporinite, and resinite. Geo-chemical and pyrolysis methods were used to analyse three maceral groups and two seam samples. The results indicate that the resinite and sporinite groups have higher extract yields, S1, S2, HI values, and pyrolysis compounds.These differences may shed light on the usage of the Huangxian lignite. Seam 2 produces more gas and oil than seam 4 does because seam 2 contains more resinite and sporinite macerals.
其他文献
A new method was proposed for tracking the desired output of chaotic dynamical system using the feedback linearization and nonlinear extended statement observer method. The feedback linearization was used to convert the nonlinear chaotic system into linea
The subsidence prediction theory under the condition of grouting into bedseparated was developed. Reducing ground subsidence by grouting was carried out on eight fully-mechanized top-coal caving faces, by using the continuous grouting in multiple-layer to
At present, coal mine fires were for ecasted with some temperature, smog, CO,CO2, etc, however, this method can\'t meet the requirements for safe production of coal mines in monitoring accuracy and validity. Overcoming these problems of foregone monitor
Based on the investigation of NOx formation mechanism, a coal-fired utility boiler whose capacity is 1 004 t/h was studied. Excessive air coefficient, inclination of burner and the way of coal supply were investigated through experimental method. Results
Porous ceramics was made from coal fly ash,and the microstructure and other properties were characterized as a function of the amount of the pore-forming agent and firing temperature.The results indicated that the proper sintering temperature for the usef
Presented the methods to obtain the cogging force of permanent magnet linear synchronous motors(PMLSMs), analyzed the characteristics of the cogging force,and provided a basis for reducing the effect of the cogging force. 2-dimensional finite element meth
Based on the theory of Fuzzy Mathematics and Expert System, this paper presents the quantitative expression method of bedded and joint-bearing rock mass quality-“Stratum Quality Index”(SQI for short), and also introduces the successful application of the
During the fixed bed tube furnace combustion experimental study,stimulated the calcium-based sorbent grain size and microstructured influencing factors to explain the fluorine retention effect influence law,and expounded the combustion fluorine retention
The volatilization behavior of Cu, Pb, Sn, Sb, Ni, Zn, Mn, Co, Cr, Cd during pyrolysis of waste printed circuit boards was investigated in a bench-scale fixed-bed pyrolysis system. It was found that volatility of heavy metals increases with operating temp
Carried on the one-dimensional analysis to the motion state of coal-gas flow in the outburst hole, and deduced the relational expression between the motion parameters (containing of velocity, flow rate and density etc.) of bursting coal-gas flow and gas p