【摘 要】
：
The volatilization behavior of Cu, Pb, Sn, Sb, Ni, Zn, Mn, Co, Cr, Cd during pyrolysis of waste printed circuit boards was investigated in a bench-scale fixed-bed pyrolysis system. It was found that volatility of heavy metals increases with operating temp
【机 构】
：
School of Chemical Engineering and Energy, South China University of Technology, Guangzhou 510640, C
论文部分内容阅读
The volatilization behavior of Cu, Pb, Sn, Sb, Ni, Zn, Mn, Co, Cr, Cd during pyrolysis of waste printed circuit boards was investigated in a bench-scale fixed-bed pyrolysis system. It was found that volatility of heavy metals increases with operating temperature elevating, and bromine and vacuum have an obvious promoting effect on volatility of most of heavy metals. Over 99% weight of Cu and Ni are still remained in solid residue after pyrolysis, about 20% weight of Sb, Zn and Cd are transfered into liquid and gas during a pyrolysis process at 600 ℃, volatilization fractions of Pb, Sn, Mn, Co, Cr are less than 10% at the same conditions. The contents of heavy metals in liquid and gas products depend on not only volatility of metals, but also their initial contents in printed circuit boards, pyrolysis liquid and gas are primarily contaminated by Cu, Pb, Sn,Sb and Zn, their contents in liquid vary from 102 to 103 μg/mL, Mn, Co, Cr, Cd were detected only at very low level, less than 10 μg/mL.
其他文献
Fulfill the screen test and float-and-sink analysis for high sulfur coal gangue from a Guizhou coal mine,analyzed the washability of its tail coal.Seen from the results:most of sulfur in sample is pyrite,the Sulfur content of different particle classifica
L3414 mechanized mining working face (No.14 coal seam) of Lingxin Mine is under the Xitian River. The mining disturbed zone where rock properties and conditions have been changed due to mining, the safety and environmental protection were concemed greatly
A new method was proposed for tracking the desired output of chaotic dynamical system using the feedback linearization and nonlinear extended statement observer method. The feedback linearization was used to convert the nonlinear chaotic system into linea
The subsidence prediction theory under the condition of grouting into bedseparated was developed. Reducing ground subsidence by grouting was carried out on eight fully-mechanized top-coal caving faces, by using the continuous grouting in multiple-layer to
At present, coal mine fires were for ecasted with some temperature, smog, CO,CO2, etc, however, this method can\'t meet the requirements for safe production of coal mines in monitoring accuracy and validity. Overcoming these problems of foregone monitor
Based on the investigation of NOx formation mechanism, a coal-fired utility boiler whose capacity is 1 004 t/h was studied. Excessive air coefficient, inclination of burner and the way of coal supply were investigated through experimental method. Results
Porous ceramics was made from coal fly ash,and the microstructure and other properties were characterized as a function of the amount of the pore-forming agent and firing temperature.The results indicated that the proper sintering temperature for the usef
Presented the methods to obtain the cogging force of permanent magnet linear synchronous motors(PMLSMs), analyzed the characteristics of the cogging force,and provided a basis for reducing the effect of the cogging force. 2-dimensional finite element meth
Based on the theory of Fuzzy Mathematics and Expert System, this paper presents the quantitative expression method of bedded and joint-bearing rock mass quality-“Stratum Quality Index”(SQI for short), and also introduces the successful application of the
During the fixed bed tube furnace combustion experimental study,stimulated the calcium-based sorbent grain size and microstructured influencing factors to explain the fluorine retention effect influence law,and expounded the combustion fluorine retention