论文部分内容阅读
一、硬件检测对于SCSI硬盘先要进行SCSI BIOS硬件检测,确认SCSI硬盘已正确连接。如果是IDE硬盘则执行下列几步: 1.把硬盘标签上的规格抄下来。确定跳线跳在了“Slave”上。用数据线插在主板的IDE槽上。 2.把BIOS改成新硬盘的数据。检查BIOS设定来确认一下。把LBA选项设成不需要。二、进行DOS分区这里有一点要注意的是,如果是大硬盘的话,必须用32位启动盘启动后才能分区(这时可以在Fdisk界面中看见新加载的硬盘),为新硬盘分一个扩展分区,并根据需要分配它的容量。
First, the hardware test For SCSI hard disk SCSI BIOS hardware to be detected first, confirm the SCSI hard disk is connected correctly. If the IDE hard disk is the implementation of the following steps: 1. Copy the specifications on the hard disk label. Make sure the jumper jumps to “Slave”. With the data cable plugged into the motherboard’s IDE slot. 2. The BIOS into a new hard drive data. Check the BIOS settings to confirm. Set LBA option not required. Second, the DOS partition One thing to note here is that if it is a large hard disk, you must use the 32-bit startup disk to start partitioning (then you can see the newly loaded hard disk in the Fdisk interface), an extension of the new hard disk Partition and allocate its capacity as needed.