论文部分内容阅读
胶接摩擦片,通常采用耐热性和弹性较好的J-04和J-15胶枯剂。胶接工艺包括调胶、表面处理涂胶、预热和固化几个步骤。 1.调胶 J-04胶粘剂是一组份包装。使用前,将胶液上下层调均匀,按胶接摩擦片数目取出所需之量,然后将瓶口封好。J-15胶粘剂为3组份包装,使用前,将甲、乙、丙三份按1:4:0.1的比例称取所需之量,然后放在一起搅拌均匀。调制时,注意掌握使用粘度,如果感到粘度过大,不易涂敷时,可用适量的乙酸乙脂稀释,边调和边试粘度,感到涂敷顺利,又不显得太稀为适宜。 2.表面处理
Glue friction plate, usually with good heat resistance and flexibility of J-04 and J-15 plasticizer. Bonding process including glue transfer, surface coating, preheating and curing several steps. 1. Tone glue J-04 adhesive is a set of packaging. Before use, glue the upper and lower layers evenly, remove the required amount by the number of friction plates, and then seal the bottle. J-15 adhesive is 3-component packaging, before use, the A, B, C three parts according to the ratio of 1: 4: 0.1 the desired amount, and then put together Stir. Modulation, pay attention to grasp the use of viscosity, if you feel too viscous, difficult to apply, you can use an appropriate amount of ethyl acetate to dilute the edge while adjusting the viscosity, feel smooth coating, but not too thin is appropriate. 2. Surface treatment