过去当线切割机在加工过程中遇到停电,由于数码管不再显示数字,往往要退回到起始点或是该段程序的起割点,重新起割。这样不仅造成时间上的浪费,且由于二次切割造成加工面粗糙,误差大。那末是否有办法,不用回退,就在停点补上该段续割指令(用手动补上)继续切割呢?经研究方法是有的。我们可以根据停电时机床上的x、y座标刻度,并结合测量 In the past when the wire cutting machine in the process of processing power outages, because the digital tube no longer shows the number, often to return to the starting point or the starting point of the procedure, restart cut. This will not only result in a waste of time, but also due to secondary cutting rough surface, the error. Then there is a way, without backsliding, stop at the point to make up the continued cutting order (with manual make up) to continue cutting it? The research method is there. We can based on the machine x, y coordinate scale, and combined with the measurement