【摘 要】
：
The thin mirrors are widely used in active optical system. In this letter, magnetic medium assistant polishing (MMAP) technology and device are discussed for thin mirrors optical finishing. The principle of MMAP is introduced, the magnetic tool for polish
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
The thin mirrors are widely used in active optical system. In this letter, magnetic medium assistant polishing (MMAP) technology and device are discussed for thin mirrors optical finishing. The principle of MMAP is introduced, the magnetic tool for polishing is designed, and the removal function of magnetic polishing tool is studied. On the basis study of the material removal function especially removal property in the edge region, the tool-path is optimized, and the dwell time distribution of computer-controlled MMAP is researched. The glass thin mirror is polished by MMAP technology. The diameter of the work-piece equals S22201 150 mm and the thickness is 5 mm. The initial surface error is 0.19\lambda (root mean square (RMS)) , and after two steps fabrication, the final surface error reaches 0.02\lambda. The experimental rsults verify that the technology is effective for thin mirrors finishing.
其他文献
Volatile Fatty Acid number (VFA no.) is one of the parameters indicating the state of quality of Para rubber latex at that particular time. Most factories analyze this parameter using standard analytical method as in ISO 506:1992(E). Nevertheless, this pr
Magnetic nanoparticle plays an important role in biomedical engineering, especially in tumor therapy. In this paper, a new technique has been developed by using the rapid moving magnetic nanoparticle under a low-frequency alternating magnetic field (LFAMF
During the last decade, striking improvements could be achieved for the precise control of deposition processes in optical coating technology. For example, as a consequence of enormous progresses in measurement and computer technology, direct optical moni
光声成像兼具光学成像对比度高和超声成像在深层生物组织中分辨率高等优点,是近年来迅速发展起来的一种生物医学成像模态。光声显微成像(PAM)是光声成像的一种重要实现方式,利用其可以无创提供活体生物组织结构和功能信息的优点,研究人员已开展了临床前和临床应用研究。为了使不同领域的研究人员了解这一快速发展的成像技术,本文综述了光声显微成像的发展现状、最新技术和研究进展。文章首先介绍了PAM的基本原理和典型的系统实现,然后概述了包括空间分辨率、成像深度、扫描方式、信号探测手段和多模态成像等方面的重要研究进展,接着阐述
辐照会引起MOS器件电介质氧化物与半导体界面势垒变化，影响其工作性能和可靠性。测量了n型6H-SiC MOS电容辐照105rad(Si)剂量前后的I-V曲线，通过Fowler-Nordheim(F-N)隧道电流拟合，得到了界面势垒的大小，辐照前的为2.596eV，辐照后降为1.492eV。界面势垒变化主要是由辐照产生的界面态引起的。
本文采用简化混合场效应模式,详细推导了45°扭曲液晶光阀的投影光光强的数学公式,给出了各种液晶光阀取向时的假彩色色度曲线;讨论了这种假彩色编码的色度特性,提出了液晶光阀最佳取向的选择原则。并讨论了液晶光阀实时假彩色编码法的调色性和混色现象等。
针对已有单光弹调制器米勒矩阵测量技术缺乏定量误差分析的不足，提出了单光弹调制器米勒矩阵测量误差方程，给出了相对误差分析方法，并结合矩阵条件数得到了降低米勒矩阵各元素最大相对误差的两组1/4波片方位角优化组合。实验结果表明，该两组1/4波片方位角优化组合，测量得到的待测1/4波片米勒矩阵各元素的最大相对误差分别为0.12%和0.20%，相比传统1/4波片方位角优化组合{-90°,-45°,30°,60°}条件下得到的各元素最大相对误差为0.83%，分别降低了85.54%和75.90%。
大阪大学在1972年开设了附属于工学部的激光技术研究设施，致力于高功率激光器的开发，并利用这种激光器进行核聚变的研究。以后，通过学术审议会的咨询,把上述研究设施加以扩充、改组，于1976年5月成立了附属于大阪大学的激光核聚变研究中心，其机能是作为日本的一个惯性约束聚变研究的中心。从1980年起开始了金刚计划，向着得失相当的目标展开工作。
本文简单报导了用脉冲氮分子激光泵浦 POPOP 染料蒸气,并对电激励染料蒸气进行初步探讨。