New High Efficiency LED Lighting Solution

来源 :Semiconductor Photonics and Technology | 被引量 : 0次 | 上传用户:xryanqd
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
As the quality of power LED improves and the cost of power LED reduces, semiconductor lighting will replace incandescent and fluorescent lighting gradually, causing another revolution on the lighting history. And its driving solution has been greatly accelerated. Based on the white power LED I-V characteristics and the application ambiance, proposed is a new LED lighting solution, suiting indoor and outdoor illumination. According to the test results, the design is optimized, and the electrical efficiency is 95% and the output current deviation is 13.0%. As the quality of power LED improves and the cost of power LED reduces, semiconductor lighting will replace incandescent and fluorescent lighting gradually, causing another revolution on the lighting history. And its driving solution has been greatly accelerated. Based on the white power LED IV characteristics and the application ambiance, proposed is a new LED lighting solution, suiting indoor and outdoor illumination. According to the test results, the design is optimized, and the electrical efficiency is 95% and the output current deviation is 13.0%.
其他文献
由于高锰钢的导热率低(仅为碳钢导热率的1/3~1/2),使得高锰钢凝固缓慢,在ZGMnl3钢凝固过程中,枝晶粗大,很容易长成柱状晶,在厚大截面的情况下或铸型导热不良时,还会出现穿晶
文中分析了外圆深切缓进磨削中磨削力的变化规律及工件烧伤机理,认为用法向磨削力Fn作为深磨烧伤的监控信号是一种简便有效的方法,并初步提出了Fn控的取值范围。 In this pa
本文用自制的高频焊管机对φ20×1mm的不锈钢管的焊接进行了试验研究。试验证明其工艺焊接性良好。试验还证明,采用相应的工艺措施可以解决不锈钢冷作硬化性强、回弹力大、以
战后的困境第二次世界大战刚结束时,联邦德国的生产能力遭到严重破坏。工业生产几乎停顿,农业产量下降,粮食不足、物资匮乏、通货膨胀导致黑市猖獗,物物交换盛行,市场极度紧
山西省社科院温朔彬、温端政著《汉语语汇研究史》于2009年10月由商务印书馆出版。全书共分六章,第一章“我国古代语汇研究概况”,第二章“20世纪初期至新中国成立前的语汇研
在过去的10年中,越来越多的人意识到负责任的公司治理在预防和发现财务报表舞弊中扮演着重要的角色。公司治理的参与方包括董事会、审计委员会、高层管理团队、内部审计师、
由国家大剧院担纲制作、北京人艺鼎力加盟的话剧《王府井》已结束首轮演出,对这部强强联手、历时三年精心打造的话剧,北京的话剧观众和评论界都寄予了厚望,那么,实际的效果又
当我们有病就医的时候,我们总希望医生开个药方,这样我们就会立即感到舒服了好多。但医生知道,药物并非总是必需的,因为有时病人所需要的仅仅是一种安慰。在这种情况下,医生
【正】进入高中以来,许多学生明显感觉到学习存在困难,达不到自己理想的学习目标。学生之间的学习成绩也有差距加大的趋向,这种现象较为普遍。如果不能及时分析其原因并给予
文中主要就金属材料的导热系数K对磨削比能u的影响进行了试验研究,结果表明,影响显著,K值越小,u值越高。 In this paper, the influence of thermal conductivity K of meta