论文部分内容阅读
Composite coatings made of nano-Y_2O_3/cobalt-based alloy and produced by crosscurrent CO_2 laser on Ni-based superalloy are introduced. Cross-section or surface of the coatings was examined to reveal their microstructure using optical microscope, SEM, including EDS microanalysis, TEM and XRD. The results show that some equilibrium or non-equilibrium phases, such as γ-Co, Cr_(23)C_6, Y_2O_3 and ε-Co exist in the coatings. Fine and short dendritic microstructure and columnar to equiaxed transition (CET) occurred by adding nano-Y_2O_3 particles. With the increasing amount of nano-Y_2O_3 (1%, mass fraction), fully equiaxed crystallization appeared. These are caused by nano-Y_2O_3 particles acting as new nucleation site and rapid solidification of the melt. The results also show that inhomogeneous dispersion of nano-Y_2O_3 results in the formation of ε-Co phase in the coatings. The sub-microstructure of the clad is stacking fault. The mechanism of the formation of equiaxed grains is also analyzed.
Composite coatings made of nano-Y 2 O 3 / cobalt-based alloys and produced by cross-current CO 2 laser on Ni-based superalloy are presented. Cross-section or surface of the coatings was examined to reveal their microstructure using optical microscope, SEM, including EDS microanalysis, TEM and XRD. The results show that some equilibrium or non-equilibrium phases, such as γ-Co, Cr 23 C 6, Y 2 O 3 and ε-Co exist in the coatings. Fine and short dendritic microstructure and columnar to equiaxed transition (CET ) occurred by adding nano-Y_2O_3 particles. With increasing amount of nano-Y_2O_3 (1%, mass fraction), fully equiaxed acetalized. These are caused by nano-Y_2O_3 particles acting as new nucleation site and rapid solidification of the melt. The results also show that inhomogeneous dispersion of nano-Y_2O_3 results in the formation of ε-Co phase in the coatings. The sub-microstructure of the clad is stacking fault. The mechanism of the formation of equiaxed grains is als o analyzed.