论文部分内容阅读
Polymer solar cells have been receiving increasing attention for the advantages such as low fabrication cost,light weight,and large size.
The optical and electrical characterization of solarcell devices based on the physical parameters of
【摘 要】
：
Polymer solar cells have been receiving increasing attention for the advantages such as low fabrication cost,light weight,and large size.
【机 构】
：
Dept. of electronic engineering, Dankook University, ＃29, Anseo-dong, Dongnam-gu, Cheonan-si,Chungna
【出 处】
：
2011年第三届微电子及等离子体技术国际会议
【发表日期】
：
2011年9期
其他文献
New Natively Textured Surface Al-doped ZnO-TCOs for Si-based Thin Film solar cells via magnetron spu
Natively textured surface aluminum doped zinc oxide (ZnO∶Al,AZO) thin films were directly deposited via pulsed direct current (DC) magnetron reactive sputtering on glass substrates.
Supersonic plasma wind tunnels with the power level of 0.4 and 2.4 MW have been constructed at Chonbuk National University (CBNU) in Korea.
Characterization of Poly-Si Thin Film Fabricated by Plasma Enhanced Chemical Vapor Deposition Method
Amorphous Si (a-Si) thin films of p+/p-/n+ were deposited on Si3N4/glass substrate for the solar cell application by using plasma enhanced chemical vapor deposition (PECVD) method.
Effects of ambient pressure and gas composition on the microstructure of μc-Si:H thin films prepared
Microcrystalline Si thin films were prepared by hot-filament-assisted reactive magnetron sputtering (RMS).The film crystallinity was readily in the absence of silane.Excellent opto-electronic properti
A wet-chemical etching technique has been used to prepare silicon arrays.The low reflectance has been identified as being potentially interesting for photovoltaic applications when using the respectiv
Single-walled carbon nanotubes (SWNTs) are quasi one-dimensional materials exhibiting interesting optical properties,which makes them promising candidates for fabrication of solar cells.
The urgent need for massively scalable carbon-free energy sources has focused attention on both increasing the efficiency and decreasing the cost of solar cells.
CuInS2 (CIS) is one of Ⅰ-Ⅲ-Ⅵ2 type semiconductors,which crystallizes in the chalcopyrite structure.CIS are one of the promising materials for photovoltaic applications because it has suitable electric
Characterization of Copper Indium Gallium Selenide Thin Films Prepared by RF Magnetron Sputtering Us
Cu(InxGa1-x)Se2 (CIGS) thin film solar cell is one of the most promising solar cells in photovoltaic devices.CIGS has a direct band gap which varied from 1.0 to 1.26 eV,depending on the Ga to In ratio
Dusty plasmas,which are ionized gases containing small solid particles,have been widely studied over the years,from processing plasma to fusion plasmas.