Preparation and strain sensing properties of carbon nanotube composite yarns

来源 :2015上海纺织服装创意创新研究生学术论坛暨第九届纺织服装创新国际论坛 | 被引量 : 0次 | 上传用户:bg8nij
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  The mechanical and strain sensing properties of carbon nanotube composite yarns(CNTs/PDMS)with different weight percent of PDMS were studied.The CNT/PDMS composite yam was prepared by infiltration method.Pictures of diameter of CNT composite yarns were obtained though polarized light microscope.Resistance change values of CNT composites under stretching were obtained though the single fiber strength tester,digital multimeter,related mechanical and electrical software.The changes of mechanical properties,electrical properties and sensing performance of pure and composite CNT yarns were discussed and analyzed.The results showed that the strength of CNT yarn declined after it was composited with PDMS polymer.In addition,the conductivity and sensing performance of CNT yarns improved significantly.The most suitable CNT composite yarn occurs at PDMS mass fraction of 1%when strength and sensing properties were all considered.
其他文献
Carbon nanotube(FCNT)yarn has outstanding high-temperature stability and excellent properties.However,few studies have looked into the interfacial properties.In this article,we report a simple method
The nanofibers membrane prepared by electrospinning method has small fiber diameter,large surface area and high porosity.These are good for bionic human extracellular matrix to promote cell adhesion a
Hollow-core cotton yarn can be obtained by using water soluble PVA filament as the core which will be removed later and cotton fibers as sheath wrapping on the core.Six kinds of fabric are studied and
Warp-knitted spacer fabric commonly used in the impact protection was selected as test materials to study the relationship between viscoelasticity and the performance of shock isolation.A damping test
In this study,a novel approach and the related equipment of coaxial electrospinning has been developed to fabricate a new ultrafine Polysulfone amide(PSA)/Polyurethane(PU)coaxial fibers at nano-scale
Measurements of the thermal conductivity of the high-performance fibers and their woven fabrics were performed using the hot wire method.The influence of the relative position between the hot wire and
Hot rolling and flat vulcanizing machine were used for bonding PAN nanofibrous membranes and nonwovens to form composite membranes.Different thickness,receiving roller speed,hot-rolled parameters,plat
In this paper,the low-speed impact damage failure process of basalt woven fabric composites was monitored by acoustic emission(AE).The collected non-stationary signal has been conducted by EMD decompo
Due to its convenience,wearability,affinity,continuously monitoring biological signal,etc,fabric electrodes used in biological signal acquisition attracted more and more interest from researchers arou
In order to prepare PAN/ZnO composite nano-fiber membranes,nano Zinc Oxide(ZnO)was dispersed into PAN spinning solution by using the methods of adding dispersing agent,ultrasonic and mechanical stirri