【摘 要】
：
In preparation of aerogels,aging in mother liquid is a common technique to enhance the strength of network, thus to restrain the pore shrinkage.However, the research of aging in mother liquid mainly f
【机 构】
：
State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology, Be
【出 处】
：
2016’中国溶胶-凝胶学术研讨会暨国际论坛
论文部分内容阅读
In preparation of aerogels,aging in mother liquid is a common technique to enhance the strength of network, thus to restrain the pore shrinkage.However, the research of aging in mother liquid mainly focused on how to fabricate shrinkage-free aerogels, and the variation of thermal insulation performance due to aging in mother liquid was seldom investigated.[1-3]In this study, the monolithic silica aerogel without cracks aged in mother liquid was prepared by the sol-gel technology under ethanol supercritical drying.Scanning electron microscopy (SEM), nitrogen adsorption-desorption analysis, different scanning calorimetry (DSC), and thermal conductivity test were used to characterize the as-prepared aerogels, and the effect of aging in mother liquid on property of aerogel was studied accordingly.Experimental results showed that the microstructure and the corresponding properties werechanged.The thermal conductivity was enhanced, thus the thermal insulation performance of aerogel was weaken.Therefore, the effluence of aging in mother liquid on thermal insulation performance should not be ignored and must be taken into consideration when aging in mother liquid was used to inhibit the pore shrinkages in aerogel preparation.
其他文献
TaC-SiC, one member of ultrahigh-temperature ceramics (UHTCs), is potentially useful as structural materials in aerospace engineering and hypersonic flight vehicles.In this paper, the synthesis and ch
Silica hollow microspheres with a single hole in the shell have been prepared by a Pickering emulsion route.The CaCO3 microspheres as template were embedded partly onto paraffin wax by a Pickering emu
A type of 4/λ-4/λ ultra-broadband antireflective coating made from modified low refractive silica and high refractive silica layers has been developed by sol-gel dipping method for amplifier blastshie
The fiber-matrix interface of C/SiC composites prepared via precursor infiltration and pyrolysis was modified by PyC interphase deposited on degummed fiber by chemical vapor deposition and heat-treate
A novel Li2S-C composite for Li-S battery cathode material was prepared by using PVP as carbon source to coat Li2S.The effects of mass ratios (mpvp∶mLi2S=0.5, 1, 1.5, 2), evaporation temperature(90, 1
A novel microwave adsorbing material that composed of graphene and epoxy was prepared by a facilesolution blending method.The microstructuresand morphologies of the graphene and the as prepared graphe
Fe-doped Titania powders were prapared using sol-gel method.by X-ray diffractometer (XRD), transmission electron microscopy (TEM), energy dispersion X-ray spectrum in scanning transmission electronic
Commercial dye has been extensively used and released into the environment which poses potential risk to human health.As a promising way for dye degradation, photocatalysis have been researched during
Using the sol-gel method, the Fe2O3 coated by silica nanocomposites with the ferric citrate as iron raw was synthesized.The clear sols were gelated at room temperature and then treated at 60 ℃ in vacu
SiO2 aerogel is a synthetic ultralight material with a very high pore volume and a large internal surface area.The latent heat storage of PCM is considered as having tremendous potential due to its hi