初调新跳汰机投产前,应进行全面润滑。一般说来,筛板应顺着矸石流动方向按1:12的坡度向下倾斜安设。排矸闸门的开口应为排放出的矸石最大粒径的1(1/4)—1(1/2)倍。各个厂家出的风阀由于一些主要性能规格都不一样,所以应按制造厂家的安装说明书进行安装和调整。各室的水阀应先开几扣作为初调,然后启动水泵,调节泵旁侧的总水阀,使跳 Initial adjustment of the new jig before commissioning, should be fully lubricated. In general, the sieve should be along the direction of waste rock slope down 1:12 installed slope. The opening of the gangue gate should be 1 (1/4) -1 (1/2) times the maximum particle size of the discharged waste rock. Each manufacturer’s air valve due to some of the major performance specifications are not the same, it should be the manufacturer’s installation instructions for installation and adjustment. Each room should be opened a few buckle buckle as the first tune, and then start the pump, adjust the total water pump bypass valve to jump