基于FPGA指纹识别系统的设计与实现

来源 :电子器件 | 被引量 : 0次 | 上传用户:huwei00
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
提出了一种基于FPGA的指纹识别系统的设计方案。论文详细介绍了指纹识别系统的基本原理、系统的总体框架结构、系统硬件结构设计和软件编程设计,以及系统的优化设计方案。该指纹识别系统使用Altera公司的Cyclone系列产品进行设计并下载实验,最后结果显示系统能够正常工作并最终实现指纹图像的快速识别。
其他文献
This study focuses on the development of a newtype of nonmetallic steelmaking slag abrasive. The performance,processing,and application of steelmaking slag as a
Steel 20Mn23AlV is a type of high aluminum steel with a very low ladle free-opening rate. The aluminum composition of 20Mn23AlV ranges from 1. 6% to 2. 45%,whic
The kinetic curves of the high-temperature oxidation of austenitic heat resistant stainless steel 1.4828 at1050℃ were measured using a weighing method.It is sh
The microstructure and mechanical properties of SA533B low-alloy steel were investigated under different cooling and tempering conditions. Steel plates cooled a
主要介绍了一种新型CMOS基准源电路的设计方法,由NMOS管阈值电压的温度系数及NMOS管迁移率温度指数形成温度补偿,同时产生低温度系数的基准电压和基准电流.此基准源电路已经
Improving the galvanizability of high silicon advanced high strength steels(AHSS) is a practical technical challenge. In this study,spot defects on an industria
This paper studies the chemical composition,tensile properties,inclusions,metallogrophic structure,and other such parameters to identify the causes of cracking
给出了计算一维有限孔径时谐辐射的一种简单的解析描述。根据线源叠加理论,在Fresnel近似条件下推得一计算辐射场的积分公式。通过用矩形函数对孔径上场分布函数的加权,并利用
The microstructural changes of Fe83Si4B13 amorphous mother alloy during the heating process were investigated by Laser Scanning Confocal Microscopy( LSCM),and the
Aluminum films coated on DI steel sheets were prepared by direct current(DC)magnetron sputtering. The influence of the deposition conditions and film thickness