故障现象主机突然停机故障原因排料口堵塞,造成料仓堵料驱动槽轮转动的三角胶带过松,造成胶带打滑偏心轴紧定衬套松动,造成机架轴承座的两边无间隙,使偏心轴卡死,无法转动工作场地电压过低,主机遇到大料时无力破碎轴承损坏排除方法清除排料口堵塞物,确保出料通调紧或更换三角胶带重新安装或更换紧定衬套调整工作场地的电压,使之符合主机工作电压的要求更换轴承 Symptom The host suddenly shut down. The cause of the malfunction. The discharge port is blocked, causing the silo to block the material. The triangular tape on the driving sheave rotates too loose, causing the tape to slip. The eccentric shaft is tight and the bushings are loosened, causing no gap on both sides of the frame bearing. Shaft stuck, unable to rotate Workplace voltage is too low, the host can not crush the bearing in the event of an expected material Damage Eliminate the discharge port blockage, to ensure that the material Tightening or replacement of apex tape Reinstall or replace the tight bushing adjustment The voltage of the work place, make it accord with the requirement of the working voltage of the host to change the bearing