单一组分与多组分城市生活垃圾孔隙率特性对比研究

来源 :岩土工程学报 | 被引量 : 0次 | 上传用户:linlin0433
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
在长期压缩条件下,城市生活垃圾孔隙率的变化规律不同于传统土力学中的土,垃圾孔隙率的变化同时受到生化降解和应力压缩的影响。基于城市生活垃圾可降解组分一阶动力学水解模型,分析建立了两种城市生活垃圾生化降解模型:单一组分生化降解模型和多组分生化降解模型。在生化降解模型和应力降解压缩模型基础上,提出了城市生活垃圾孔隙率计算模型。通过分析不同上覆应力(10,50,100,200,400,800 kPa)长期作用下的孔隙率变化,综合比较了不同生化降解模型以及垃圾组分和降解特性对孔隙率变化规律的影响。对于国内现阶段生活垃圾而言,多组分生化降解模型基础上预测的孔隙率变化规律与单一组分生化降解模型的分析结果一致,孔隙率随着长期压缩和降解的进行逐渐增加。然而,相比于单一组分生化降解模型,多组分生化降解模型更能反映垃圾组分及可降解组分降解能力对孔隙率变化规律的影响。 Under the condition of long-term compression, the variation of the porosity of municipal solid waste is different from the soil in traditional soil mechanics. The change of the porosity of the rubbish is affected by biodegradation and stress compression at the same time. Based on the first-order kinetic hydrolysis model of municipal solid waste biodegradable components, two biodegradation models of municipal solid waste were established: one component biodegradation model and multi-component biodegradation model. Based on the biodegradation model and the stress-strain model, the calculation model of the porosity of municipal solid waste is proposed. By analyzing the changes of porosity under different long-term stresses (10, 50, 100, 200, 400 and 800 kPa), the effects of different biodegradation models and the components and degradation characteristics of the waste on the porosity variation were comprehensively compared. For the domestic MSW, the predicted porosity variation based on the multi-component biodegradation model is consistent with the analysis results of the single-component biodegradation model. The porosity increases with the long-term compression and degradation. However, compared with the single-component biodegradation model, the multi-component biodegradation model can better reflect the influence of the degradability of trash components and degradable components on the variation of porosity.
其他文献
在土工格栅加筋风积沙、土工网垫加筋风积沙以及未加筋风积沙地基条件下,开展了3个不同尺寸斜柱扩展基础上拔水平力组合荷载作用下9个工况的现场试验。根据基础的顶部荷载与
随着社会主义市场经济发展经济战略的实施和股份制经济发展,以直接融资为主要特征的证券市场也逐步形成并迅速壮大.与此相适应,近几年来,全国各地证券经营机构快速发展,除了
SAR图像配准是实现多时相图像监测的前提,但是由于SAR图像的斑点噪声、成像机理的特殊性,使得采用常规的特征匹配方法很难实现SAR图像的自动配准。本文在介绍旋转尺度不变特
基于国内水平旋喷技术存在成桩质量差、加固体周围岩土体变形大等问题,以中国京冶工程技术有限公司开发的全方位高压喷射注浆新工法及相应设备为依托,进行了水平旋喷拱棚现场
为了研究土的含水率不变时土的抗剪强度与有效应力的关系,根据土的卸载抗剪强度的计算方法,结合超固结土与正常固结土的应力关系,分析了加载和卸载过程中土的抗剪强度的变化
在传统物质点方法的基础上发展了用于饱和多孔介质动力学分析的两相物质点方法(two-phase material point method,tMPM)。由于饱和多孔介质由固体骨架与孔隙流体组成,两相物
目前,在地应力测量和应用中,人们常常用近于水平的两个主应力或其在水平面上的投影来代替或估计最大和最小水平应力,这在一般情况下误差不大,但是当应力结构比较特殊时这种代
目的 分析战斗机飞行员着某型囊式个人防护装备,在不同余压值条件下加压呼吸对心功能的影响。方法 男性志愿者4名,年龄18~20岁,穿着某型囊式代偿抗荷服配头盔及面罩,在地面加
针对爆炸成腔与爆炸衬砌对周围介质密度的影响进行了数值模拟和现场试验研究。应用Dyna-2D软件进行数值模拟研究的结果与近20多年以来相关的研究结论基本一致。数值模拟研究
利用空心圆柱扭剪仪(HCA)施加竖向—环向耦合循环荷载模拟波浪荷载的作用,对船载散装铁精矿进行了动力特性试验。通过对动应变、动强度和孔隙水压力变化曲线进行分析,探讨了