论文部分内容阅读
3.短路SSP板上的S26与S27测试点飞利浦FL2G机心彩电,I2C总线进入/退出维修状态方法进入维修状态方法:打开电视机后盖,找到小信号处理电路板(SSP板)上S26、S27测试点。通电开机后,瞬时短路S26与S27测试点,电视屏幕上出现如图11所示维修菜单,则说明电视机已进入维修状态。退出维
3. Short-circuit the S26 and S27 test points on the SSP board Philips FL2G Telepresence, I2C bus Enter / Exit the maintenance status Method To enter the maintenance mode Method: Open the rear cover of the TV and locate the small signal processing circuit board (SSP board) on S26, S27 test point. Power on, the instantaneous short circuit S26 and S27 test point, the TV screen appears as shown in Figure 11, the maintenance menu, then the TV has entered the maintenance state. Exit the dimension