Heat transfer characteristics for double-jet in different flow regions on a thick plate

来源 :钢铁研究学报(英文版) | 被引量 : 0次 | 上传用户:zhengpeng19860223
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
During multi-jet cooling,the complex hydrodynamic characteristics caused by the interaction between jets will affect the heat transfer of the plate.To further clarify the heat transfer characteristics in different flow regions,the double-jet cooling experiments were completed on a 50-mm-thick plate with the initial cooling temperature and jet angle in the range of 300-900 ℃ and 0°-60°,respectively.The inverse heat conduction was used to calculate the surface temperature and heat flux.Furthermore,the rewetting phenomenon,maximum heat flux and maximum cooling speed were studied.The results show that increasing the angle between jet and wall normal would increase the wetting front\'s width downstream of the jet point.When the jet angle was 60°,the maximum value increased by 37.29 mm compared with that when the angle was 0°.The correlation between the width of the wetting front and the radial temperature gradient was further confirmed.In addition,it was found that the maximum heat flux would be affected by the duration of transition boiling,but not affected by complete wetting time.The results clarified the heat transfer mechanisms under various initial cooling temperature and inclination angle conditions on plate cooling in different flow regions,and provided valuable data for controlling heat transfer efficiency and improving cooling uniformity.
其他文献
建立了测定水中毒死蜱气相色谱测定方法.水中的微量毒死蜱用二氯甲烷萃取浓缩后,在载气氮气的作用下经进样口250℃高温,通过DB-1701石英毛细管色谱柱,在柱箱变温程序控制下,柱流量为1 mL/min,使用NPD检测器,在检测器温度330℃、氢气3.0 mL/min、空气60 mL/min、尾吹氮气10 mL/min条件下分析,以保留时间定性,外标法定量.该方法检测毒死蜱的线性范围为0.1~2.0 mg/L,最低检出浓度为0.0012 mg/L,相关系数≥0.999,浓度为2.75~285μg/L加标水样的
建立了一种采用吹扫捕集-气质联用法同时测定水中乙醛和丙烯腈的分析方法.结果表明,拟合得到的标准曲线线性良好,相关系数均大于0.995,乙醛和丙烯腈的测定下限分别为0.6和1.5μg/L,加标回收率为90% ~115%,相对标准偏差为0.73% ~6.0%,满足检测方法的建立要求.该方法简便快速,灵敏度高,定性定量准确可靠,可同时满足对生活饮用水、地表水、地下水等水样中痕量乙醛和丙烯腈监测的要求.
2020年底,为了降低寒潮来袭给老小区供水设施造成的严重影响,常州通用自来水有限公司对9个片区的老小区采用间歇性供水方式.寒潮结束后,对户表管故障数据和水表故障数据的分析显示:间歇性供水小区对比非间歇性供水小区户表管和水表的故障率都是下降的,尤其是户表管故障率;室外户表管的保温措施需要改进,应适度增加保温层厚度;应保证小区总阀和排污阀状态正常,否则会影响间歇性供水效果;晚上23点到早上6点停水会影响应间歇性供水效果,应适当延长间歇性停水时间.
Two distinct regimes of strain rate sensitivity on yield strength are found in a high-strength nantwinned steel.The yield strength increases from 1410 to 1776 MPa when the strain rate increases from 10-3 to 1400 s-1.It is proposed from the measured small
In the contemporary electric arc furnace (EAF) steelmaking industry,increasing contents and temperature homogenization via fluid flow stirring is found to be an effective method of improving production quality and smelting efficiency.It is a trend for dif
Poor permeability and low sintering productivity restrict the development of high-bed sintering.An efficient method of the double-layer sintering process (DLSP) was proposed to achieve high-bed sintering and solve the aforementioned problems.Theoretical c
以中药渣(TCMR)为原料,采用真空热解方式制备中药渣生物炭,通过扫描电镜(SEM)、比表面积及孔径分析仪、傅里叶红外光谱(FTIR)等表征手段进行分析.中药渣生物炭的BET比表面积为808.6 m2/g,平均孔径是0.97 nm,表面有大量活性官能团.静态吸附实验结果表明,pH=7时中药渣生物炭对活性蓝19的吸附量最高;中药渣生物炭对活性蓝19的吸附过程符合准二级动力学模型(R2>0.994)和Langmuir吸附等温线(R2>0.996),最大吸附量达到85.47 mg/g.热力学分析表明该吸附过程是
At present,the continuous accumulation of the flue gas desulfurization (FGD) gypsum in steel plants leads to the serious environmental issues and resource waste.To achieve green and sustainable development for the steel industry,it is significant to impro
The stability of the Fe23Zr6 phase in Fe-Zr system was studied,and the partial Fe-Zr phase diagram was revised by means of X-ray diffraction,electron probe microanalysis and differential thermal analysis methods.On the basis of the experi-mental results i
基于2019年台儿庄城区饮用水水源地水质监测数据,探讨了水源地水质的季节变化特征,采用内梅罗综合指数法对其进行了评价.结果显示:与《地下水质量标准》(GB/T 14848—2017)指标限值相比,仅张庄水源地水质中总硬度超标,其余指标符合要求;张庄水源地水质指标的质量浓度大于小龚庄水源地;张庄水源地水质处于良好级别,小龚庄水源地水质处于优级别.