论文部分内容阅读
由于种种原因,排灌水泵的泵轴轴颈的磨损,是经常发生的。一条加工复杂,造价较高的泵轴,往往因一处或二处轴颈的磨损,而需要废旧换新,这是十分可惜的。这里介绍几种轴颈磨损后的简易处理方法: 1.打毛处理 7.5Kw以下的泵轴颈,直径方向的磨损量在0.05毫米以下,可以采用用圆冲在轴颈上冲出密密麻麻的小孔。其孔径大小及深度,可视轴颈大小和磨损情况而定。这种方法处理的轴颈,与配套接触面很小,短时间以后,可能松动。只能作为临时处理措施。
Due to various reasons, irrigation pump shaft pump shaft wear, is often occurs. It is a shame that a complicated and expensive pump shaft is often worn out due to the wear and tear of one or two journals. Here are some simple ways to wear after the journal wear: 1. To deal with the following 7.5Kw pump shaft journal, the diameter of the wear and tear in the direction of 0.05 mm below, you can use the round punch on the journal out of dense small hole. Its aperture size and depth, visual journal size and wear may be. This method of processing the journal, and supporting the contact surface is small, a short time later, may be loose. Only as a temporary measure.