2000年第10期《建筑工人》刊载的《楼梯踏步模板设计》一文谈到,楼梯支模设计时,将楼梯踏步最下边一步的挡板高度加高,最上边的一步档板高度减少。我认为这种作法不妥。楼梯踏板的厚度是设计人员通过计算确定的,而这种作法恰恰改变了楼梯板原设计的厚度,可能出现两种结果:一是如果中间段楼梯 In the article “Staircase Step Template Design” published by “Construction Worker”, it is mentioned that the height of the baffle at the bottom step of the staircase step is increased and the height of the top one step baffle plate is reduced during the design of the branch mold. I think this is not a proper solution. The thickness of the stair tread is determined by the designer through calculation, and this approach just changed the thickness of the original design of the stair slab, there may be two results: First, if the middle section of the staircase