论文部分内容阅读
在NC加工机床上,采用试切的方法验证NC程序往往耗时长且效率低,本文介绍了一个用于NC立铣床的NC模拟程序,提出了一种独特的切削模拟及三维图形显示方法.用这种方法不但可以大大简化立体图形的隐藏线的处理而且可以得到逼真的立体图形效果.本程序用VB语言编写.
数控铣削加工的计算机仿真的研究
【摘 要】
：
在NC加工机床上,采用试切的方法验证NC程序往往耗时长且效率低,本文介绍了一个用于NC立铣床的NC模拟程序,提出了一种独特的切削模拟及三维图形显示方法.用这种方法不但可以大
【机 构】
：
南京航空航天大学机电工程学院南京
【出 处】
：
南京航空航天大学学报（英文版）
【发表日期】
：
2004年期
其他文献
The DOF of human being was analyzed in this paper. Three reasonable kinds of DOF disposition programs came up to design a humanoid robot and an optimal DOF disp
分布式应变传感器对大型重要工程结构的应变状态的实时测量具有重要的应用价值.本文研究了一种基于光时域反射技术的准分布式光纤应变传感器系统,沿光纤分布各局部点的应变信
The gas flow in exhaust manifolds has much effect on scavenge, pumping loss and exhaust energy utilization of turbocharged diesel engines. This paper presented
A genetic learning algorithm based fuzzy neural network was proposed for noisy image restoration, which can adaptively find and extract the fuzzy rules containe
目的 探讨产妇产前喂奶体位模拟训练及产后母乳喂养指导提高剖宫产产妇母乳喂养成功率的效果.方法 将产妇按入院单双日分为对照组、试验组各100例.对照组产妇进行常规护理,即
The control system of HLS (Hefei Light Source) is based on EPICS.The control data is held in a distributed database, which resides in several IOCs. An EPICS too
目前中国进行公司制改组 (现代企业制度改革 )的真正实现需要许多条件 ,笔者主要从董事所负义务角度进行探讨 ,将国内外立法对董事所负义务进行了比较论述 ,分析了中国董事难
As the main component of computer integrated manufacturing system (CIMS), flexible manufacturing system (FMS) should be an open system with reusability and exte
A fast encoding algorithm was presented which made full use of two characteristics of a vector, its sum and variance. In this paper, a vector was separated into
Fuzzy Logic Control (FLC) is a promising control strategy in welding process control due to its ability for solving control problem with uncertainty as well as