Transition characteristics for a small tail-sitter unmanned aerial vehicle

来源 :中国航空学报(英文版) | 被引量 : 0次 | 上传用户:q19070
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Research on the transition phase of tail-sitter Unmanned Aerial Vehicles (UAVs) is cru-cial for trajectory planning and performance analysis.This study focuses on the analysis of the tran-sition characteristics and path of a small dual-rotor tail-sitter UAV,including static and dynamic computations.The system input time delay and actuator dynamics are specifically considered dur-ing the dynamic analysis,and these actual physical properties ensure that the computation results are reliable and reasonable.The UAV steady-state limit is obtained through static analysis,which is also adopted to verify the correctness of the dynamic results.In regard to the dynamic analysis,sev-eral typical transition approaches are computed based on different initial states and optimization objective functions,and the different computations are applicable under specific task conditions.The off-line dynamic results of the transition path and actuator output sequence could also be adopted as reference values for the transition process during real flight.A comparison of the static and dynamic results illustrates the necessity of combining these two methods for UAV transition characteristic analysis.Furthermore,the UAV conceptual parameters related to the transition path are also studied,and the obtained quantitative characteristics provide feedback for the UAV con-ceptual design.
其他文献
To investigate the effect of tip clearance size on cavitation characteristics in a turbopump inducer,a series of experiments have been conducted in a newly developed visualization test facility using room temperature water as working fluid.The pressure fl
文章对辽宁省旱涝成因以及前期海温外强迫特征进行了剖析。研究表明辽宁夏季降水存在显著的季节内特征,初夏主要受东北冷涡的影响,两者之间存在显著负相关关系。初夏东北冷涡强度指数与两个海温关键区的相关系数,分别为0.38和0.45,均超过信度为0.01的检验。
The low-speed wind tunnel experiment is carried out on a simplified aircraft model to explore the influence of wing flexibility on the aircraft aerodynamic performance.The investigation involves the measurements of force,membrane deformation and velocity
SiCp/Al composites are difficult-to-cut materials.In recent years,electrical arc discharge machining has been developed to improve the machinability of these materials.However,there is a big challenge to build a satisfactory heat transfer model of SiCp/Al
Electrically Controlled Rotor (ECR),also called as swashplateless rotor,applies blade pitch inputs via trailing-edge flaps system instead of traditional swashplate mechanism.In addition to primary control,rotor vibration reduction and noise alleviation ar
The present study performed a numerical investigation to explore the performance enhancement of a co-flow jet (CFJ) airfoil with simple high-lift device configuration,with a specific goal to examine the feasibility and capability of the proposed configura
Emissions produced by the aviation industry are currently a severe environmental threat;therefore,aviation agencies and governments have set emission targets and formulated plans to restrict emissions within the next decade.Hybrid aircraft technology is b
In this paper fretting fatigue crack behavior in 1045 steel is studied by in-situ observation and finite element analysis,in-situ fretting fatigue experiments are conducted to capture real-time fretting fatigue crack formation and propagation process.The
Reasonable and effective fatigue load spectrum is key of aircraft structural fatigue test.Two kinds of load spectra simplification approaches based on statistical consistent fatigue damage model are proposed in the paper.One method is to simplify the orig
The multiple jets impingement heat transfer is widely applied in the wing anti-icing sys-tem.It is challenging to apply the similarity criterion to carry out the anti-icing experiments due to the complex flow and heat transfer behavior.In the present stud