论文部分内容阅读
根据国家技术监督局1993～1994年国家标准制(修)订计划和冶金工业部(1993)冶质字第027号文的要求,由上海钢管股份有限公司和福建省冶金工业研究所负责起草的钢管涡流探伤检验方法国家标准,1994年12月在海南省召开的审定会上通过了审定。审定会由冶金部信息标准研究院主持。参加会议的有冶金部、中国有色金属工业总公司所属的9个单位共13名代表。 会议上首先由上海钢管股份有限公司起草人李福良高工介绍了本标准采用国际标准ISO9304—1989(E)修订GB7735—87的情况,并对送审稿的编制做了详细的阐述,与会代表对送审稿进行了认真的、逐条逐句的审查,提出了具有建设性的修改意见。与会代表
According to the requirements of State Bureau of Technical Supervision 1993-1994 National Standard System (Revision) and Ministry of Metallurgical Industry (1993) Metallurgical word 027, Shanghai Steel Tube Co., Ltd. and Fujian Provincial Institute of Metallurgical Industry drafted Eddy current testing of steel pipe test methods of national standards, in December 1994 at the validation meeting held in Hainan Province passed the validation. Validation by the Ministry of Metallurgical Information Standards Institute. Metallurgical Ministry attended the meeting, China Nonferrous Metals Industry Corporation owned nine units a total of 13 representatives. At the meeting, Prof. Li Fuliang, the drafter of Shanghai Steel Tube Co., Ltd., first introduced the revision of GB7735-87 of this standard using the international standard ISO9304-1989 (E), and elaborated the preparation of the draft for review. The participants The reviewers conducted a serious, article by sentence review, proposed constructive changes. Delegates