【摘 要】
：
The microstructural constituents and the crystallographic morphology of the primary intermetallic phases in permanent-mould-cast Mg-Zn-Al alloys with typical co
【机 构】
：
College of Materials Science and Engineering,Department of Materials
论文部分内容阅读
The microstructural constituents and the crystallographic morphology of the primary intermetallic phases in permanent-mould-cast Mg-Zn-Al alloys with typical compositions within high zinc castable domain were investigated. Three kinds of primary compounds with distinct morphology were identified as Mg32(Al,Zn)49(τ) M gZn(ε), and a ternary icosahedral quasi-crystalline compound (denoted with Q). The constituent is found to change with Zn and Al content and their concentration ratio. Alloys with middle mass ratio of Zn to Al and Al content, consist of α-Mg and τ phase, while alloys with high mass ratio of Zn to Al and low Al are composed of α-Mg, ε and a small amount of τ, those with low ratio of Zn to Al and high Al consist of α-Mg with Q.Solidification characteristics and process were proposed. The solidification ranges and liquidus temperature decrease with increasing Zn and Al content for τ- and Q-type alloys, whereas ε-type alloy shows reverse tendency. The second phase transformation moves to higher temperature range when Al content increases and ratio of Zn to Al decreases.
其他文献
党的十八大报告指出,要坚持走中国特色新型工业化、信息化、城镇化、农业现代化道路.本文剖析云南省“四化”同步发展的现状和面临的难点问题,进而探讨了促进云南“四化”同
Superplastic deformation mechanism of AZ31B magnesium alloy sheet was investigated. Maximum elongation of 216%and strain rate sensitivity of 0.36 were obtained
CuOx/CeO2 catalysts were prepared by adsorption-impregnation method.CO conversion was tested over the catalysts pretreated under different conditions for prefer
Oscillating heat pipes (OHPs) are very promising cooling devices. Their heat transfer performance is affected by many factors, and the form of the relationship
Concepts and techniques of response surface methodology have been widely applied in many branches of engineering, especially in the chemical and manufacturing a
Cell attachment and spreading on Ti-based alloy surfaces is a major parameter in implant technology. Ti39Nb-13Ta-4.6Zr alloy is a new β type Ti alloy developed
随着广东建筑业地迅猛发展，人们越来越关注建筑工程建设中的现场施工管理工作。因为它不但关系着人的生命与财产安全以及影响着社会稳定发展，而且也是一切工作能够顺利进行的基
Silicon carbide (SiC) foams with a continuously connected open-cell structure were prepared and characterized for their mechanical performance. The apparent den