【摘 要】
:
Composite metastable TiN and Ti1-xAlxN coatings with different Al content were deposited on 1Cr11Ni2W2MoV stainless steel for aero-engine compressor blades by a
【机 构】
:
Jiangxi Key Laboratory of Surface Engineering,State Key Laboratory for Corrosion and Protection
论文部分内容阅读
Composite metastable TiN and Ti1-xAlxN coatings with different Al content were deposited on 1Cr11Ni2W2MoV stainless steel for aero-engine compressor blades by arc ion plating. The results show that all coatings have a B1NaCl structure and the preferred orientation changes from (111) to (220) with increasing Al content; the lattice parameter of Ti1-xAlxN decreases with the increase of Al content. The oxidation-resistance of (Ti,Al)N coatings is significantly improved owing to the formation of Al-riched oxide on the surface of the coatings. The nitride coatings can significantly improve the corrosion-resistance of 1Cr11Ni2W2MoV stainless steel under the synergistic of water vapor and NaCl, and the corrosion-resistance becomes better when the Al content increases, because not only the quick formation of thin alumina layer prevents the further corrosion but also the formation of alumina seals the pinholes or defects in the coatings, which prevents the occurrence of localized nodules-like corrosion.
其他文献
Rare earth composite materials radiating far-infrared rays were prepared according to far infrared absorption spectrum of main component in liquefied petroleum
Diamond-like carbon (DLC) films were prepared by PLD process using 308 nm(XeCl) laser beam with high power (500 W) and high frequency(300 Hz). The effects of ni
In order to improve the strip quality of continuous roll-casting process (CRP) of aluminum alloy, the investigations of the flow behavior within the metal pool,
Distribution of localized damage in shear band can t be predicted theoretically based on classical elastoplastic theory. The average damage variable in shear ba
Employing isothermal and isochronal differential scanning calorimetry, an analytical phase transformation model was used to study the kinetics of crystallizatio
The packaging poses a critical challenge for commercialization of MEMS products. Major problems with the packaging process include degraded reliability caused b
The precursor precipitation of InVO4 was synthesized by co-precipitation using indium trichloride (InCl3),ammonium metavanadate (NH4VO3) and ammonia (NH3-H2O) a
Ferroelectric devices are widely applied in many fields, such as energy conversion and communication. The aging effect in ferroelectric materials plays a centra
Solid oxide fuel cell is attracting more attention in recent years for its lower pollution emission and high energy convert efficiency. La0.9Sr0.1Ga0.8Mg0.2O3-
The preparation technology and magnetic properties of Nd9.5Fe77B6Co5Zr2.5 nanocomposite magnets were investigated by melt spinning and crystallization process.