论文部分内容阅读
熔融金属的流量控制是利用一对三相200V平面式直线感应电磁泵来进行研究的。两个容量各为11.5千伏安的电磁泵放在垂直注管的两侧,它产生与金属自由下落的方向相反的力。所用的熔融金属是铝合金和铸铁。对于铝,当输入电压从0增至200V时,流量从1.20公斤/秒减少到0.83公斤/秒。最大流量控制率达到30％。对于铸铁,泵的输出能量不足以控制流量,因与铝合金比较,铸铁的电感应能力较低。这些结果已被理论所证明,并已获得设计电磁泵所必需的数据。
Molten metal flow control is the use of a pair of three-phase 200V planar linear induction electromagnetic pump to carry out research. Two solenoid pumps, each with a capacity of 11.5 kilovolts, are placed on either side of the vertical tube and create a force that opposes the direction in which the metal free-falls. The molten metal used is aluminum alloy and cast iron. For aluminum, the flow rate was reduced from 1.20 kg / sec to 0.83 kg / sec as the input voltage increased from 0 to 200V. The maximum flow control rate of 30%. For cast iron, the output of the pump is not enough to control the flow rate, as cast iron has lower electrical induction than aluminum alloy. These results have been proven in theory and have obtained the data necessary to design a solenoid pump.