在金属薄板的冲孔、落料加工中,通常都是由人工手持板料在冲模上定位并断续送进冲切的.这种加工方法,劳动强度大,效率低,且材料利用率也不高.现介绍一种简便易行的随模自动送料装置.其结构及工作原理如图示.该装置是在常规冲裁模结构基础上,在上模一侧附加一个拨料滑爪,并于其外再装一个复位簧片(可由拉簧等取代).下模(包括卸料板)对应部位开一向下倾斜30°～45°左右的滑槽,作为滑爪工作运行的导轨,并拆除下模上原有的挡料销.该装置在冲模上下一个 Punching in the metal sheet, blanking, usually by hand-held sheet metal positioning in the die and the intermittent feed into the punching.This method of processing, labor-intensive, low efficiency, and material utilization Is not high.A simple and easy to introduce with the automatic feeding device.Its structure and working principle shown in Figure 1. The device is based on the conventional stamping die structure, And then install a reset reed outside (which can be replaced by a tension spring, etc.) The lower mold (including the discharge plate) corresponding parts open a chute tilted downward about 30 ° ~ 45 °, as a sliding jaw work run guide, And remove the original material on the lower punch pin. The device in the die on the next one