氧气瓶的安全使用,主要应抓好以下六个环节。一、充气前的安全检查。氧气瓶在充气时程中,往往会发生瓶嘴“冲天”事故和瓶肚臌胀事故,这是由于瓶嘴滑扣或锈坏,水压试验过期或有降压使用瓶混入所造成的。因此。做好氧气瓶充气前的安全检查工作,是保证氧气瓶安全使用非常重要的一环,切记不可粗心大意,马虎从事。1、当发现有撞伤、凹陷、烧伤、划伤,以及瓶身腐损、油浸碱泡和充填过其他气体的氧气瓶及瓶嘴退扣或损坏、瓶座脱落的氧气瓶,均不能随意充氧,要送交有关部门进行检查鉴定,可以继续使用者才能充氧(不能继续使用者,要作出降压使用或给予报废处理的决定)。2、当发现瓶脖下的定期检验钢印超过有效期者,必须重新进行技术检验,同时要重新做水压试验,检查、试验合格后方可充氧。二、搬运。在实际生产中,有些搬运工和氧气瓶使用人员不注意安全搬运,特别是在天冷地滑的冬季里, The safe use of oxygen cylinders should mainly focus on the following six steps. First, safety inspection before inflation. During the inflating time of the oxygen cylinder, bottleneck “blowout” accidents and bottleneck inflation accidents often occur. This is due to slipping or rusting of the bottle mouth, the expiration of the water pressure test, or the use of a bottle of antihypertensive drugs. of. therefore. Doing a good job in the safety inspection before filling the oxygen cylinder is a very important part of ensuring the safe use of the oxygen cylinder. Remember that care should not be taken carelessly. 1. When there are bumps, dents, burns, scratches, and bottle body spoilage, oil soaked alkali bubbles, and oxygen cylinders filled with other gases, and the bottle mouth is retreated or damaged; Oxygen is to be sent to the relevant department for examination and identification. The user can continue to be oxygenated (can not continue to use the user, it is necessary to make a decompression use or to give the decision to end). 2. When it is found that the regular inspection of the seal under the neck of the bottle exceeds the expiration date, the technical inspection must be conducted again. At the same time, the hydraulic pressure test must be performed again. After the inspection and test pass, the oxygen can be oxygenated. Second, handling. In actual production, some porters and oxygen bottle users do not pay attention to safe handling, especially in the cold winter days,