【摘 要】
：
Gadolinium gallium garnet (GGG) nanopowders doped with ytterbium ions (Yb:GGG) were synthesized with citric acid as a fuel via gel combustion method. The optimi
论文部分内容阅读
Gadolinium gallium garnet (GGG) nanopowders doped with ytterbium ions (Yb:GGG) were synthesized with citric acid as a fuel via gel combustion method. The optimized conditions for preparing Yb3+:Gd3Ga5O12 nanopowders were discussed. The heat behavior, struc-ture and morphology of powders were analyzed with thermal analysis (TG-DTA), X-ray diffraction (XRD), infrared spectra (IR) and trans-mission electron microscope (TEM). TG-DTA analysis revealed that the weight loss of the precursor occured below 800 ℃ and its crystalli-zation temperature was 830.6 ℃. XRD and IR analysis showed that the precursor converted directly into pure GGG at a relatively lower tem-perature (900 ℃) without any other intermediate phase. The lattice constant was 1.2377 calculated by extrapolation method. TEM results in-dicated that the spherical powders showed good dispersity and had a relatively narrow size distribution with average particle size of approxi-mately 40-50 nm, which was favorable for good sinterability of Yb:GCG laser ceramic.
其他文献
The evolution of texture during the annealing and hot rolling process of extruded AZ31 magnesium alloy sheets was studied. There are two kinds of texture compon
The quality of micro heat pipe(MHP) is strongly affected by sealing technology. Based on the analysis of requirements of sealing technology, a cold welding tech
Ba-Al-S-Eu sputtering target for blue emitting phosphors was prepared by powder sintering method. XRD patterns showed that the main components of the target wer
Effect of Co substitution and annealing treatment on the formation, magnetic properties and microstructure of (NdOyTb)12.3(FeZrNbCu)81.7CoxB6(x=0-15) ribbons pr
Microscopical techniques were used to provide the semi-solid microstructure evolutions of ZK60+RE alloys formed by compression and equal channel angular extrusi
A series of Eu(Ⅲ) complexes of α-thenoyltrifluoroacetone(HTTA) with trioctylphosphine oxide(TPPO) and benzoic acid(BA) or its two derivatives, p-toluic acid(P
The effect of environmental temperature on the damping capacity of Cu-7.66Al-9.52Mn (mass fraction, %) alloy was studied. The result shows that with increasing
In order to accelerate the conversion coating formation on 6063 Al alloy in the Ce(NO3)3 solution, accelerants of chloride and ammonium salt were used. The coat
The wetting property of (Sn-9Zn)-2Cu (wt pct) on Ni substrate and the evolution of interfacial microstructure in (Sn-9Zn)-2Cu/Ni joints during soldering as well
In chloride system, thermodynamic analysis is a useful guide to separate lead and antimony as well as to understand the separation mechanism. An efficient and f