在DK-420多头钻床上钻削摆线减速机法兰盘连接孔时(图1),装夹和定位不便,所以,我们设计了翻转钻模,以法兰盘轴承定位,将法兰盘扣装在钻模板上,然后翻转钻模板180°进行钻孔。利用该钻模在多头钻床上加工可提高工效8倍。底座1(图2)上安装支座2,支座2内装有转轴(未标出),转独与左、右角板4相连。钻模板5架在两角板上,工件安装在钻模板5上,用心轴7定位,然后翻转 When DK-420 drilling machine drill drilling cycloid reducer flange hole (Figure 1), the clamping and positioning inconvenience, so we designed the flip drill, flange bearing positioning, the flange Buckle mounted on the template, and then flip drill template 180 ° drilling. Using the drill in the multi-head drilling machine can improve work efficiency 8 times. Support 2 is mounted on the base 1 (FIG. 2), a shaft (not shown) is installed in the support 2, and the handle is connected to the left and right angle plates 4. Drill template 5 rack on the two corners, the workpiece mounted on the drill template 5, with the mandrel 7 positioning, and then flip