论文部分内容阅读
现将我科(第一设计院金工科——编者)采用的药水瓶翻版印刷法作一简单介绍。1.制样片(母图):①利用已有的各类机床图形凹凸锌版,将上面的污垢用汽油或煤油清洗干净,让其干燥。③将转印油墨和少量的4号、5号或6号印刷油(其中的任何一种均可)调和:但不可太稀,以能滚开为准。为了使锌版少受浸蚀,也可加点普通油墨,混合在一起使用。调和工作可在一块较厚的玻璃板上进行,用刮腻子的小铲或坚固的小刀研磨一会,调匀即可,然后在玻璃板上薄薄地涂一层油墨。③普通的油墨滚子用汽油或煤油洗净后,薄薄地涂一层转写油墨,平放在锌版上,反复滚几次,等一切线条都沾上油墨后,转90°,再滚一次油墨,是沿上方向同样地滚。在这道工序上应该注意的是,油墨
Now I Branch (First Design Institute of Metalworking - Editor) using the vial pigeonhole printing method for a brief introduction. 1. system sample (mother map): ① the use of existing types of machine tools convex zinc plate, the above dirt with gasoline or kerosene to clean, let it dry. ③ The transfer ink and a small amount of 4, 5 or 6 printing oil (either of them can be) reconcile: but not too thin, to be able to get off. In order to make zinc less erosion, but also add some ordinary ink, mixed together. Reconciliation work can be carried out on a thicker glass plate, ground with a spatula or firm knife for a while, and thoroughly mixed with a thin layer of ink on a glass plate. ③ ordinary ink roller wash with gasoline or kerosene, a thin layer of transfer ink, flat on the zinc plate, repeated several times, all the lines are stained with ink, turn 90 °, and then roll Once the ink is rolled up in the same direction. In this process should be noted that the ink