【摘 要】
：
The metallurgical effect of a round tundish used to cast heavy steel ingots in machine works at present was evaluated through water modeling experiments.The flo
【机 构】
：
College of Materials Science and Engineering
论文部分内容阅读
The metallurgical effect of a round tundish used to cast heavy steel ingots in machine works at present was evaluated through water modeling experiments.The flow control devices of the improved oval tundish,which was used instead of the round tundish,had been optimized.The results show that the residence time of the round tundish is short,its inclusion removal efficiency is too low,and it has more dead zones and an unreasonable flow field.Compared with the round tundish,the improved oval tundish with the optimized weir and dam has a better effect:its minimum residence time is prolonged by 38.1 s,the average residence time is prolonged by 233.4 s,its dead volume fraction decreases from 26％ to 15％,and the ratio of plug volume fraction to dead volume fraction increases from 0.54 to 1.27.The inclusion removal efficiency also increases by 17.5％.
其他文献
2011年重庆市住院医师规范化培训工作（简称住培）全面启动，重庆医科大学附属儿童医院以提高岗位胜任能力为导向，采用“戴明环”式管理，利用形成性评价的各类考核量表进行学员过程考
We present a new approach based on honey-bee mating optimization to estimate the state variables in distribution networks including distributed generators. The
This paper proposes an analysis and a direct power control (DPC) design of a wind turbine driven doubly-fed in-duction generator (DFIG) under unbalanced network
A multivariable regression (MVR) approach is proposed to identify the real power transfer between generators and loads.Based on solved load flow results,it firs
This research develops a novel feasible approach to fabricate Fe-Pt bimetallic nanoparticles (NPs).The overarching goals are to provide guidelines for the desi
This paper first introduces a way to improve interactivity with high polygon count virtual objects through the "mixed" use of image-based representation within one object. That is, both 3D polygonal a
Chip multiprocessors (CMPs) allow thread level parallelism,thus increasing performance.However,this comes with the cost of temperature problem.CMPs require more
A rational approximation method of the fractional-order derivative and integral operators is proposed.The turning frequency points are fixed in each frequency i
A numerical procedure for analyzing the temperature distribution in a hollow axisymmetric cylinder,made of functionally gradient material (FGM),was investigated
17-4PH stainless steel powders were prepared using a supersonic nozzle in a close-coupled gas atomization system.The characteristics of powder particles were ca