论文部分内容阅读
本处在施工中用环氧树脂作为粘接剂粘接基础与垫铁。1施工前的准备工序（1）将基础上垫铁位置的表面凿平，其面积稍大于汽轮机所带垫铁。凿平过程中，用两平面平行度不大于0．02／1000的平垫铁作试块。（2）将基础所凿平面凿出麻点，麻点深度不大于5mm，每个所凿平面麻点数大于
The Department in the construction of epoxy adhesive as the basis for bonding with the horn. 1 pre-construction preparation process (1) based on the location of the horn chisel surface, the area slightly larger than the horn with the turbine. Chipping process, the flatness of the two planes parallel to not more than 0.02 / 1000 flat horn as a test block. (2) Digging the ground by the base plane, the depth of the pitting point is not more than 5mm, and the number of pits per digging plane is greater than