【摘 要】
：
Iron(Ⅲ)-doped nanostructure TiO2-coated SiO2 (TiO2/SiO2) particles were prepared using the layer-by-layer assembly technique and their photocatalytic property
【机 构】
：
College of Chemistry and Material Science,Key Laboratory of Advanced Film of Hebei Province
论文部分内容阅读
Iron(Ⅲ)-doped nanostructure TiO2-coated SiO2 (TiO2/SiO2) particles were prepared using the layer-by-layer assembly technique and their photocatalytic property was studied. TiO2 colloids were synthesized employing the sol-gel method with TiCl4 as a precursor. The samples were characterized by Fourier transform infrared spectroscopy (FTIR), SEM, EDS, XPS, and XRD. The experimental results show that TiO2 nanopowders on the surface of SiO2 particles are well distributed, the amount of TiO2 is increased with the adding of coating layers, the pure anatase-TiO2 coating layers are synthesized at 500℃, and the photocatalytic activity of Fe3+-doped TiO/SiO2 is higher than tnat of undoped TiO2/SiO2.
其他文献
The feedstock based on the binder 65 % PW-30 % EVA-5 % SA has the best general rheological properties for the 17-4PH stainless steel powder. The 17 4PH stainles
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥
The influences of the flux KCl or KF on the XRD patterns, cell parameters, crystal morphology, and spectral properties of the phosphor LaMgB_5O_(10)∶Ce~(3+), M
通过对福建沿海城市近5年的大气污染物排放状况的调查,分析了盐密与大气污染物浓度的关系,建立大气质量指数,并验证大气质量指数与盐密的相关性,在此基础上建立了大气质量指
A new method is given to increase doping concentration of p-type ZnSe up to 1× 10i8 cm-3 through adding a little Te. This method gets over the difficulty of th
Poly(phthalazinone ether sulfone ketone) (PPESK) was melt blended with bisphenol-A polysulfone oligomer (O-PSF)to produce a thermoplastic polymer blends. The mi
BIOSS4 steel is essentially a nickel-free austenitic stainless steel developed by the Institute of Metal Research, Chinese Academy of Sciences, in response to n
On the basis of transformation kinetics and thermodynamics, the austenite-ferrite transformation start temperature during deformation was predicted for several
Optical microscope and scanning electron microscope were used to observe the microstructure of the Al-11.6%Si and Al-11.6%Si-0.4%Mg alloys and the morphology of
By combining the α/γ interface migration and the carbon diffusion at the interface in Fe-C alloys, a mathematical model is constructed to describe the mixed-c