【摘 要】
：
In this study,we computationally examined the dynamics of dielectric barrier discharge in hydrogen sulfide.The simulations were performed with a 1d3v particle-in-cell/Monte Carlo collision model in which a parallel-plate electrode geometry with dielectric
【机 构】
：
State Key Laboratory of Safety and Control for Chemicals,SINOPEC Research Institute of Safety Engine
论文部分内容阅读
In this study,we computationally examined the dynamics of dielectric barrier discharge in hydrogen sulfide.The simulations were performed with a 1d3v particle-in-cell/Monte Carlo collision model in which a parallel-plate electrode geometry with dielectrics was used.Particle recombination process is represented in the model.The discharge mode was found to be initially Townsend discharge developing from the cathode to the anode,and at the peak of the current,a more stable glow discharge develops from the anode to the cathode.A higher applied voltage results in sufficient secondary electrons to trigger a second current peak,and then the current amplitude increases.As the frequency is increased,it leads to the advance of the phase and an increase in the amplitude of the current peak.A higher dielectric permittivity also makes the discharge occur earlier and more violently in the gap.
其他文献
在航天航空领域,增材制造板状结构因其优异特性而得到广泛应用.但是增材制造结构件在制造或者使用过程中极有可能会产生不同类型的缺陷,从而造成安全隐患.本文基于兰姆波在平板中具有多个路径的传播形式,提出了一种利用二次到达波的缺陷无损检测方法,并应用于增材制造平板的缺陷定位.首先,根据兰姆波的频散特性确定激励信号的中心频率和模式.设计兰姆波在板中的多种传播路径,通过预先设置的压电片传感器接收二次到达波.通过波速和消耗时间来计算从传感器到缺陷的距离,以传感器为中心、以测得的传感器到缺陷的距离为半径做圆,进而利用两圆
In this study,the neutral gas distribution and steady-state discharge under different discharge channel lengths were studied via numerical simulations.The results show that the channel with a length of 22 mm has the advantage of comprehensive discharge pe
刚体的构形可用其质心位置和姿态矩阵描述.刚体的位置可以在欧几里得空间中表示,但是其姿态矩阵是在李群上演化的.由于李群独特的非线性性质,基于欧氏空间的多体动力学建模与数值算法难以完全真实地描述系统的动力学特性,特别是长时间历程的动力学特性.本文基于几何力学理论,首先根据离散Ham-ilton变分原理与离散Legendre变换,建立了多刚体系统的Hamilton体系李群变分积分公式.其次,给出李群变分积分公式的两种离散格式:一般离散格式和RATTLie离散格式.最后,采用这两种不同离散格式构建的算法计算了重力
In this work,the gyrokinetic eigenvalue code LIGKA,the drift-kinetic/MHD hybrid code HMGC and the gyrokinetic full-fcode TRIMEG-GKX are employed to study the mode structure details of reversed shear Alfvén eigenmodes(RSAEs).Using the parameters from an AS
This work proposes a new plasma super-phase gradient metasurfaces(PS-PGMs)structure,owing to the limitations of the thin-layer plasma for electromagnetic wave attenuation.Based on the cross-shaped surface unit configuration,we have designed the X-band abs
Limited particle transit time is one of several limiting factors which determine the maximum temporal resolution of a Langmuir probe.In this work,we have revisited the known fast sweep Langmuir probe techniques in a uniform,quiescent multi-dipole confined
The coaxial surface wave linear plasma with preeminent axial uniformity is developed with the 2.45 GHz microwave generator.By optical emission spectroscopy,parameters of the argon linear plasma with a length over 600 mm are diagnosed under gas pressure of
The effect of gas pressure on ion energy distribution at the substrate side of Ag target radio-frequency(RF)and very-high-frequency(VHF)magnetron sputtering discharge was investigated.At lower pressure,the evolution of maximum ion energy(E)with discharge
The positioning service aided by low Earth orbit (LEO) mega-constellations has become a hot topic in recent years. To achieve precise positioning, accuracy of the LEO clocks is important for single-receiver users. To bridge the gap between the applicable
液体晃动会对飞行器动力学和控制系统造成影响,为了降低液体晃动带来的负面影响,本文从被动控制角度出发,对常见的Cassini贮箱提出几种防晃设计方案,并探索不同因素对贮箱防晃性能的影响.通过Flow3d商业流体软件对比分析环形挡板贮箱、扇叶挡板贮箱、环形浮板贮箱的性能后,给出了一种挡浮板复合结构贮箱,并通过对比验证了这种思路的可行性.